Hi, not sure if you can help me on this. I have tried to enable failover mode but it just doesnt work for me.

My setup :

1. Primary Router : AX86U
2. Maxis Router : AR2140
3. Maxis 4G Backup Dongle : MF833V
4. Fiber Infra : Unifi (on high rise)

Steps :

1. Plugged in MF833V into AR2140
2. LAN 1 (from AR2140) to LAN 1 (AX86U) - nothing else plugged into AR2140, Primary WAN on AX86U is on 2.5Gbps port
3. Enabled Dual Wan on faileover on AX86U (Primary WAN 2.5Gbps port, Secondary WAN on LAN 1)
4. In AX86U page, it shows as primary WAN connected by secondary WAN as cold backup
5. Switch off BTU, internet disconnected by waited 5 mins no failover (no internet connection)

Any ideas?

Hi rathishsiva,

Does the AR2140 have any Internet access after step 5?

Thank you

Hi, thanks for the reply. Yes it does. When I connect directly via WiFi to AR2140 it has internet access. The dongle is blinking blue too.

Quick question:

If I am using Unifi, with AC82U router.

If let’s say I have 5G Router, can I dual WAN or blend both Fiber+5G to achieve higher speed?

Quick question:

If I am using Unifi, with AC82U router.

If let’s say I have 5G Router, can I dual WAN or blend both Fiber+5G to achieve higher speed?

Quick question:

If I am using Unifi, with AC82U router.

If let’s say I have 5G Router, can I dual WAN or blend both Fiber+5G to achieve higher speed?

Does RT-AX56U support Google Assistant?

https://www.asus.com/support/FAQ/1046212/ it show supported from this page, but from the router only Alexa is available.

Don't bother, Google assistant for routers only do a few actions below.

Anyone know how to setup Lyra MAP-AC2200 with Maxis? There is no option to change the VLAN to Maxis profile.

Hi, does anyone here know what features(if enabled) would disable NAT acceleration on tuf-ax4200?

Hi yongtjunkit,

Any features that control the traffic such as QoS or bandwidth limiter will disable the NAT acceleration.

Thank you

I see, this means that adaptive QOS would disable NAT Acceleration?

When doing the speedtest, do make sure the QoS and AiProtection is disabled.
Thank you

Hi @ASUSmy,

Hi have a PPPoE account that comes with 5 public IPs (/29) from local telco.  Is it possible to use Asus router to assign those IPs via DHCP to my clients and use WAN IP as it's gateway.  I have not found any guide only to do this.  Appreciate your feedback on such setup.

Thanks

Hi @ASUSmy,

Hi have a PPPoE account that comes with 5 public IPs (/29) from local telco.  Is it possible to use Asus router to assign those IPs via DHCP to my clients and use WAN IP as it's gateway.  I have not found any guide only to do this.  Appreciate your feedback on such setup.

Thanks