bro our frens can boot mah... u can ask him lo.....

. . . you guys don't really read all the posts from the beginning do you

Hi Hi. I first time overclock my Q6600.
I have question to ask:
what situation will cause prima95 error during test?

below is my success overclock by following beginner guide


After that i try increase bus speed to 330. (ya only bus speed. other didn't touch) temp stay at 68'C. after 5minits one of four core get error.
How can? which part i making mistake

You just increase the fsb but u didnt increase the vcore, surely not enough juice for the proc n at the same time it might be the heat problem later on becos the more vcore u increase the more hotter it will be, n presently already 68c so be careful of your temp

I believe you're using Intel stock heatsink right?
This is what I did, following what's the guide provided.
At 1.35v, we can do 320x9, which is 2.88Ghz.
So I raise the voltage to 1.40v, and the FSB to 335x9, I get 3.01GHz.
But the proc will get hotter eventually, which is around 75'C +/-.

This post has been edited by Shufflerz: Jan 31 2009, 10:22 PM

I dont think u have to increase to 1.4v to get 3.01g, i think 1.3v will get u there, i still remember when i was using Q6600 i just set 1.325 to get 3.2g stable like a rock ( 400x8 ) n temp full load around 59c but my proc n heatsink both lapped.

This post has been edited by Dickong: Feb 1 2009, 07:07 AM

Using Zalman CNPS8700
Since give me this kind of temp result. I better stop at 2.88Ghz before i change better cooler.
But the Max i can go only 3Ghz because my ram only 667

Unlink the freq ratio for CPU to RAM.

My KVR limit is only 857, so for me to go higher freqs with my Q6600, I disable the link

---

Added on February 1, 2009, 12:32 pmUnlink the freq ratio for CPU to RAM.

My KVR limit is only 857, so for me to go higher freqs with my Q6600, I disable the link

This post has been edited by shaun3230: Feb 1 2009, 12:32 PM

Another method is to lower the fsb n increase the multiplier if it is not up to your maximun multiplier yet

My current temp on 3.6ghz daily setup IBT/LinX stable.

You have a good temp showing there, with 1.47vcore n at 3.6g n manage to get below 60c is a good temp.

That is the power of real man liquid cooling,not those toy cooling

is that idle or load? Cause if its idle, its real hot. Mine is less than 40c, aorund 36-38c idle

That is full load. You can see it in CoreTemp.

-pWs-

Ok, wow, thats low for a load. U can push some more for higher freqs

Can you classified what is toy cooling?????

How about this ?


Attached thumbnail(s)

1.52v looks to be ur wc's limit ... but very good temp for 1.4v @@... mind telling me ur wc setup? @@@@

Toy cooling ar:
Thermaltake Big Water
Cooler Master(Corrosion )
Coolit(Not fine for 65nm quad core with high vcore )

Your nirox pump is also a toy pump