go update ur HU....
if u updated ady, then pray it just blinks for that time only...

most of us, early birds have this problem, but after HU update, the problem, touchwood, never happen again...

You need SQ then. I don't drive Preve but here is what I did on my old proton's HU to work to desired level:
1. Used old school Blaupunkt 4ch amp. RM150.
2. Half cut Blaupunkt speaker. RM90
3. Cables + installation. RM70.

I choose 4ch amp over the component speaker as it allow for wider future upgrade which never happened till I passed my ride to my other half.
Component speaker is definitely cheaper as you can DIY it using the existing cables.

So this total only rm310? So cheap?
Will it void any of my warranty?

void engine warranty.

Joking only, void the HU warranty and wiring warranty.

Seriously I doubt those setup can bring into a decent SQ setup, unless you found good component speaker set at RM90? I doubt so, even if it used.

A decent SQ unit shall comes with a good component speakers set, a decent 4 channels amp, a subwoofer. Else to me, that's still far to be said as a complete SQ setup. At least a decent componen speaker to start with.

This post has been edited by allenultra: Jan 21 2013, 11:02 AM

oldies goes for SQ..

i mostly listen to trance,dj(ATB,AVB,Tiesto....etc)...what setting should i go?
budget budget d la,1k-2k..without change HU,bass no need too strong(i dont wanna BOOM BOOM until car macam pecah d)

after bonus out will throw some money for that

i noob in ICE

Hi guys, don't know if any of you still remember or not but I got good news !! ; The Proton Prevé Wikipedia page looks damn chun now. It used to be like this. Today, thanks to help from various PREVOC members, it looks much better.

Cheers, and thanks again for all of your help.

i at world car care sri petaling now anddddd those guy say they never do ecu remap and never do antirust spray.. i tot can do at any sc zzz

SQ setup can produce SPL output, but not vice versa.
Visit EA Autoworks for some suggestion?

A good component speakers, 4 channel amp, a subwoofer in the boot, done.
You might not need to focus a lot on clarity for the component speakers, then u can lower done your budget by a bit.


Again, SQ isn't just about oldies....

This post has been edited by allenultra: Jan 21 2013, 11:30 AM

nice!! good job bro!!

okie...will pay a visit to there soon...

CFE reporting in! Next week should arrive, loan approved.

Other than the ECU reflash and overcrank, are there any other issues? Can I have these changes done when I get the car, or only at 1K km service?

Maybe TS or some nice chap can help with a newbie owner Preve guide! Thanks in advance all sifus!

LOOKING FOR PREVE GREATEST DEAL ?
welcome to pm me /click on the link below

I think ur car will not need the ECU update. Check ur chasis no first, according the the service center SA only earlier batches will need the reflash.

Just to chk wif u guys.. If changing the HU will the steering ctrls abt to work?

Hi kenlui, thanks for your response! I'm getting the 2012 manufacture - where do I check the chassis no.? I read earlier the 16xxx chassis needs to reflash? Am I right?

Is it possible to know what month the Preve was manufactured in? If yes, how?

Also, if it does need to reflash, any SC that does it in kota damansara area? If not, what's the nearest/best place to do it? Im browsing the service centre's on proton's website... hope I wont need to call every one and ask if they provide reflash... hahah

Feel really excited now! Thanks again!

mutiara damansara,bukit maluri PESC they provide reflash ECU..these 2 are SC nearest to Kota Damansara

dammit, I am going to curse the guy who did this to my preve just now..

My car is in the parking lot and not obstructing anyone.

Guys, where to get the FIXIT pen in PJ? I need to do this asap.




Attached thumbnail(s)

Remap my ECU recently, now my CVT executive can fly~~~.. fuel consumption stable at 10L @100km/h