Would u think this will applies on budget P35-DS3 too?

ermm..noob question..mobo must support quad core ah?mine support onli duo core..can i use quad?

Please check Asus website for processor compatibility.

Just got my Q6600 up and running, cooled by an Ultra 120 Extreme and a low cfm Delta fan. At 2.6Ghz full load, Core temp shows 84c/83c/78c/79c for the 4 cores while Easy Tune shows 61c

Is your Q6600 Rev. B3? That's hot...

Yup, it's a B3.

Oopss..... your's a B3 stepping....

What does core temp show for your tjunction?

This post has been edited by kmarc: Aug 5 2007, 08:30 PM

The tjunction temp is 100c.

Weird. Then it's correct (B3 has a tjunction of 100'c). By right core temp should be indicating the correct temperature.

Have you tried Intel's TAT (thermal analysis tool)

It's supposed to be other apps that reads the temperature wrongly. See this : http://www.boogleoogle.co.uk/category/hardware/

You sure your HSF is seated properly?

We need a quad expert here!!!!

time to move bro! get those phase change la

I'm at 2.8Gghz right now, highest coretemp is 90c while eazy tune shows 70c. I've reinstalled the heatsink already. The weird thing is that when I touched the lower part of the heatsink while under full load, it's not even warm!

Still too lazy to install my Prommy

Thats quite hot @ 2.6GHz and cannot blame 100% on B3 stepping maybe air ventilation not so good.

might a bug i think.. zZZzz
if not even warm, then its ok de

if it's not even warm...means the heat transfer no good la...

I've tried reinstalling it already, the outline on the base of the heatsink shows that there's proper contact. I'm currently using the Thermalright Ultra 120 Extreme, turned the screws all the way down already. Will do it again tomorrow. Might also try using the stock heatsink for comparison.

hi, just wanna share some idle temps of this g0 q6600 under water..

setup:

c2d q6600 g0 L72..
gigabyte p35t dq6
2x 1gb kingston hyperx ddr3
hd 2900xt 1gb ddr4
cooltrek radiator 1203, dtek fuzion cpu waterblock, laing d5 pump, distilled water
corsair hx620w

Q6600 g0 idle temp @ stock



Q6600 g0 idle temp @ 4.05ghz 1.6vcore



Q6600 g0 idle temp @ 4.14ghz 1.65vcore

now is load temp for this q6600 g0 under water..

occt 15mins @ 1.475vcore 3.7ghz..




This post has been edited by irenic: Aug 6 2007, 02:44 AM

why the z-cpu's voltage is always 1.138???

how to set my spec break 3.2

i now stuck at 3.2ghz(400x8)

cant go 3.6 .zzzzz

i also wonder y my ddr2 hyperx 800 shown 667 only.....

even all packaging and sticker is 6400.....zzz...help

brother kvmcom and others...

you have the same exact problem like me....

have you tried stock heatshink?