Include installation around how much? Is it better than proton Ori parts?

installation around 150-180 i think.. cant recall, change damn long ago. I would say the same as proton ori or slightly more harder. harder means slightly more vibration but lesser torque loss.

Engine mounting kong will causing torque loss? Mine I think also gone, now mileage 88k only but already vibration on idle. I tried to maintain clean throttle body and good spark plug condition to make my engine healthy (less vibrating) to extend the need for replace engine mounting...

guys,

my 9 yrs old persona when driving above 40km/h will have some vibrations on my steering especially when reeving hard, send in for checking and sc says is the drive shaft problem although there is no kluk kluk sound when turning left or right. Proton ori drive shaft cost about RM1000/pair while oem is only about rm400-500/pair. Oem is less than half, need advise if it is really worth it to go for ori?

Have you check for wheel balancing? Might be that simple.

Hi arrsoo, mostly your issue is drive shaft bar have minor dent that why vibrations in low speed. Normally when turning have kluk kluk sound that is drive shaft head internal wear and tear. As my advise you can consider aftermarket brand like GSP brand because half price compare ori.
Proton Ori drive shaft from GKN maker of course life span and quality better...

already check, not wheel balancing problem

noted, thanks bro

Thanks bro.

I got it from proton parts centre just now.




Attached thumbnail(s)

just replaced timing belt at proton authorised sc, timing belt set alone cost rm285, labour rm270, is it acceptable ? Or too expensive ?

This post has been edited by delsoo: Oct 3 2020, 02:21 PM

My 9 years Persona come back the 'tuk tuk' sound when turning the steering. I remember this is common issue during that time, and i have change the Power steering pipe & Orifice Valve that time.

Any idea how to solve this irritating sound?

i got mine replaced in 2018, at normal shop, used Proton stuff got charged RM400 (including labour)

just changed as per Zen's recommendation



RM147.04 from Shopee, labour not sure how much since did other stuff too



old mounting for the lulz

This post has been edited by persona93: Oct 9 2020, 08:27 AM

are Anshin Co. Ltd drive shaft reliable? was quoted RM 245 each side.

asking for original most work shop say expansive some they say they never order original proton drive shaft before.
proton sc say original drive shaft is about RM800 ! !!

Gaido, Muteki, and mounting king not sure which one are good



This post has been edited by ngeo88: Oct 11 2020, 02:01 PM

Muteki, Saiko and Mounting King - all these 3 are good

Gaido betrayed my trust before

Gaido is good. GSP and Anshin are the cheapest one u can get. Gaido going for 370 per pair in Shopee.

Ya, after chg can feel lotsa difference.

Your bonnet collecting rust in the workshop now. 😂 😂 😂

Going to purchase persona manual,any good advise?

This is thread for the old IAFM Persona that's based on Gen2 ya... If the persona you looking at is Iriz based Persona, do check out at Persona VVT thread.

Guys i have read up on somewhere that having LSD can provide the ride EBD like safety features in car that don't have EBD built in.

Any idea of limited slip differential that is available for our model?

This post has been edited by inferno_17_85: Oct 22 2020, 03:05 PM

Indeed, i'm looking for PERSONA SV