Replace the brake switch. Make sure its length is adjusted properly as well

Brake switch got anything to do with the jerking?

The car's computer reads the brake signal to decide on whether to engage, disengage, or engage the clutch partially. If the switch is gone which is possible due to the lousy quality, it can have poor contact causing erratic signal output to the computers.

Other than this, could be the brake pedal is not pressing against the switch sufficiently over rough roads when it is not depressed, thus causing a brake/no brake signal to be produced randomly especially when the road is bumpy. This is why the switch has to be adjusted correctly. Enough to stay closed, yet not so deep that it fails to produce brake signal quickly when the pedal is depressed.

It's only between 20 to 30 RM, original. Buy from PPC as it should have the latest stock.

This post has been edited by TDUEnthusiast: Dec 23 2019, 10:01 PM

Have you update firmware and reset the ECU?

Thank you.

5th Year with the Suprima and warranty ending this year. Wondering whether if it's a good idea to keep it, or let it go..

no major problem so far with the car? i suggest you just keep it

Yeah no major problems so far, car had to be tolled back to SC once due to gear lock button stuck and couldn't engage any gears, but that's it

Been sending to 3S centre for service on time. Only thing I don't like about the car is how noisy it is (engine/gearbox/CVT), the stiff suspension and also the poor fuel consumption

Just to share my SS reverse camera finally died after 5yrs of use. It costs RM280 for the original replacement part. Labour charge for installation at SC is RM50. Thought of DIY but don't dare to risk cutting wire and wrong connection might shock the fuse. If do it at accessories shop will be cheaper but not the original wiring maybe cut here and there.

The original camera looks simple but very costly compare to readily available cam in market. Only difference is the wiring.

anyone facing problem boot cannot release? try both using remote and switch also cannot

This post has been edited by muss90: Feb 7 2020, 03:16 PM

Lama tak visit thread ini...
Hi guys, anyone having issue of "one side of headlamp" keen spoiled (bakar) non stop?

Any permanent solution for this problem?

Good morning all sifu.

I just got a second hand ss, the issue is the h.break light n esp light come n go! after reading some sifu post all having the same problem,just like to know how to setter the problem. Tq

The car also having L.side light bulb burn, gear stick black plastic damaged, driver seat at the back support hve sound! rocker cover start to leak........................


Almost all the problem all sifu have my car having!

Do you hear some noise from the boot when you operate the switch/remote? If yes the motor is either weak, or the link between the motor and boot latch release is broken. If not it might be something else. Bring to a trusted service centre and get them to help diagnose, or if you have some car troubleshooting skills, start looking from the interior fuse box if there's no sound coming from the motor in the boot.

I personally never experienced this. Some say additional grounding will help, some blame it on bulb quality/replacement process, i.e. bulb was contaminated during installation. In any case get a branded H7 bulb replacement, or just go to somewhere like EA Autoworks and get them to recommend a better alternative

1. Might be related to the brake switch. It's just RM2x from Proton Parts Centre or any Proton's SC. Don't buy it from anywhere else if you're looking for this part. If not get the car scanned by Proton or by a trusted workshop to see what's the issue.

2. Possible solutions are branded bulb replacements, additional grounding, changing headlamp bulb socket, etc.

3. Buy a new replacement for the gear lever.

4. Not much you can do about the original seat as most owners will suffer from this. A car upholstery shop may be able to help by stuffing additional materials inside the seat, but ask them first.

5. Rocker cover seal replacement will cost between Rm100 to RM120 at a proton SC including original parts and sealant. All campro engines have this issue, and many will start exhibiting this problem as early as 60,000km

so.. did you get it?
cause i been thinking of finding 1 cause work required me to travel alot.

Hi guys, any recommendations for tires?

Where did you done for the tuning?

This post has been edited by heavensea: Mar 4 2020, 02:10 PM

EA Autoworks. They're the only one who offer MBO for proton CFE models

This?
https://forum.lowyat.net/topic/4385871/all

Damage brp?

Forgot to mention.. it's RM6xx now I think. If you don't actually want to keep your car for too long, maybe find someone whose car you can try first before deciding. I haven't seen any negative reviews yet though

Hi, new SS member here. I bought an used SS Dec last year, 2016 premium model. So far no major problems, just minor rattling and parking sensors not working. Not a big deal for me as i always love the car. Just want to ask few things.

1. So i recently checked the fuse box in the driver side and i noticed there were some fuse went missings. I cross check and one of it is RR wiper fuse, but the rear wiper is working fine. Is it normal like that?

2. When i went on a sharp bump, i noticed the the steering vibrate quiet harsh and the sound also. Is it related to the arms or others?

Tq in advance.

Hi All,

How is everyone doing during MCO?
Ada warm up kereta tak?