2014... the price now is around 2X,000 .. no value... some even is around 1x,000

Yes. My office also in the midst of letting go the 1st batch preve cfe (4 airbag) for less than rm20k each.

You may check it out here : https://www.tanyaje.com.my/cardetails/used/...n-6-airbags/407

Not a 2014 produced one...but 2016, that comes with 6 airbags..

I'm still driving this late 2014 model. Will be clocking 160000km soon. A good and reliable car. Sayang want to jual coz the resale value is quite low. Once I get a newer car this preve would be a good 2nd car

you can DIY replace it. Check this youtube guide.
https://www.youtube.com/watch?v=4meOOvA0Mvk&t=8s

I plan to do this in near future. but first need to prepare replacement dashboard garnish. Mine one will mostly break when i open it. I did quite alot DIY open and put back the garnish trim.

Anyone knows where to buy gear knob bush for preve?

Guys, anyone tried change headlamp to led type? How the spring can clip in ah? Mine is the ribbon type philips ultinon essentinal h7. I see guide macam need take out the spring but macam not easy eh. I see even got fan punya also need take out spring right? If not the spring cannot clip in becos the spring is block bu the fan or the ribbon type heatsink

my high beam is philips ultinon essential gen2 with fan type. To remove bulb just rock the bulb yp and down slightly after removing the power connector leads. there is no spring clip lock for high beam. you will get the hang of it and pull the bulb out

take note of the bulb filament alignment before you take out and ensure same direction for LED ship. Should be vertical.

connect the LED plug correctly as it needs correct polarity, filament bulb polarity doesn't matter

ohh.. but the low beam got clip.. got ppl share me at youtube said need to install the ring adapter first.. maybe need a small allen key yo secure it

im using the same, this is the one with the blue ribbon right? no need to change the ring filter.

- first your halogen bulb ring filter is not removable if you check it. no need to change ring filter it will fit correctly
- second you need to remove the bumper to have access to remove the headlamp, there's screws under and on the side of the bumper only then can remove the headlamp, its hard to replace this without removing the headlamp.
- third the led ribbon won't fit in the rubber enclosure, need to poke a hole so it can extend outside the headlamp enclosure ( will share photo later)

dunno if you saw this video before, if not, the video looks stupid, but I think its effective guide
skip to 5:55

high beam no need to install the adapter ring first, whole LED bulb just plug back in make sure the clips latch on to the black plastic ring with the LED chip facing exactly sideways is the right way

I am using this kind of LED light.

Guys, need ur input...Driving 2012 CFE, from time to time always hard to start, like need to crank twice only can start, so didn't pay much attention to it...But last week, as usual, everytime when first time start, need to crank twice only can start, then after drive around, off it, go take breakfast, then want to start again, crank for 4-5 times only can start, after that, no more cranking for the rest of that day...

So I'm looking for recommendation on which outside workshop that experienced in solving cranking related issue...

Initially thinking to go back service center, but change my mind choose outside workshop better

this one first thing to check is change battery (i suggest amaron if you're replacing) and spark plugs.
sounds like battery not strong so need to drive around for alternator to charge the battery, but thats just my initial guess base on your description.

if you haven't done change battery and spark plugs in a while then this is the time.

This post has been edited by caloyness: Dec 1 2020, 12:43 AM

just changed to new batter this year during end MCO time
probably spark plug...
but if goto prevoc fb group, there got few different suggestions about this
the usual cause of this issue is OCH, which i know about this on the 3rd or 4th year since this model launched


anyway, is spark plugs changes according to mileage or according to duration?
for example, engine oil need to change every 5000km or 6 months, regardless u drive alot or no, when 6 months duration, need to change engine oil...

I suggest u go to workshop with those ecu reader. Straight away can detect what of the root cause of problem.

Bro is it tis number or pw812665?

https://shopee.com.my/product/28079707/3155...53-1606816850.9

The number u show macam is proton persona or gen2 saga punya

This post has been edited by ben3003: Dec 1 2020, 06:01 PM

I referred to first page. Ts put pdf list of parts price

Anyway will check tomorrow. Mine is no turbo btw

ohh okok.. maybe diff. cos i see shopee for preve cfe they show tis. the car only have 1 kind of oxygen monitor right? i saw for preve macam it is connected to the turbo area.