what's wrong with this..is it ram prob or proc?


Attached thumbnail(s)

use memtest to check whether it's ram problem. if no error during memtest, it should be cpu problem.

What mobo u using?
My athlon 2800+ max can only 238fsb

i'm using abit nv8..stable only at fsb300..once add another 5, errors start to happen

i dun think its memory prob coz the speed now is at 200 with stock voltage..the highest i can go without memory error is at 230mhz..now i'm trying new setting ..the voltage for the cpu in bios is at 1.58v for this new setting when error occurs..do i need to add more or is there other way? or izit temp issue?

I got Prob Oc this rig.. Whenever i increase it Frequency it will start to hang.. Dunno y hard to OC this rig.. Can any sifu teach me as im new in amd..

Nope. Speed doesnt determine everything. U have to look at the timings as well.

the voltage and timing is at default..pass mem test oredi..

Hmm... im a nOOb here... Hope all sifu can help me...

Anyone here got a guide on tweaking ram for DFI nf4 Lanparty Ultra-D?

I oredy noe the how to oc the CPU from the Fundamentals of Overclocking sifu....

but i dunno how to tweak ram for the mobo... hope can help me

Open up your A64 tweaker. Look at Max Async Latency and read preamble. They aint same as default anymore. I dont know about other mobo, but for this mobo, it changes with divider.

Brother go to dfistreet.com and you will have everything you can ask for for your dfi mobo

U need to loosen the memory timings in order to go higher. It depends also which ram youre using while increasing the ram clock.

U need to increase the voltage when u increase the clock.

if it changes, what should i do?never experienced A64 before.. ..need to tighten the timing or loose it?

rules of thumb:
to look for max speed, loose timings
once identified oc limit, start tightening one by one
which one? its trial n error

Owh.. But how bout the ram voltage? using tccd chip max how much voltage for stabilty?

TCCD won't like high voltage. Some people spoiled their TCCD after running with more than 3.0V for a while.

I would say the safe range would be 2.8V - 2.9V. The lower the better.

This post has been edited by soulfly: Sep 25 2006, 10:48 PM

TCCD run damn hot at high frequency...

Got Another prob here..
i use AMD64 tweaker.. suddenly when i change settings at bios.. it didnt follow the bios setting.. clear cmos oso the same.. Im suppose to format comp again?

Tccd Vs Bh-5 Vs D-43.. which one u prefer for amd Ocing..?

board does matters here. if ur on dfi lp, i wud say bh-5 & tccd are the better choice. both can do high frequency w/ d board mentioned, w/ d latter need lower voltage.

This post has been edited by footie: Sep 26 2006, 08:47 AM