AMD K8 Family Discussions

This post has been edited by soulfly: May 4 2007, 09:23 AM

my pc spec

amd 64 3000+
KVR 512mb ddr400 x2 (double sided)
winfast 6600gt
msi k8n neo4-f mobo


ok, the problem is that when i run on 1:1 divider(250 fsb,250x9=2.25Ghz,,3X htt) PASS;

but when i wanna test how high my proc can go ,so i have to use divider,

5:6 divider(166mhz ram) even cannot pass 240 fsb(240x9).. FAIL.

what should i do??pls help

This post has been edited by realone: Jan 3 2006, 07:42 PM

act.. ualrady got thread to ask...http://forum.lowyat.net/index.php?showtopic=139453

anyway.. ermm bout ur prob.. u dun tell us wat test was pass

r u sure u r using 166mhz divider ? check it at cpu-z... and print screen it here and also other related info...

btw u using 1T timing or 2T ?

ok,run on 1t

what test was pass and what test was fail?

is there any other divider that you can use besides 5:6?

i think is my ram problem..before i upgrade to 512x2,,,,256 x2 is running fine and can reach 300mhz fsb.......

try to raise ur HT bus speed multiplier to 4X.

try 1T same result?

higher LDT wont help, try to use 1 stick ram n c

ok, i will try later

ok, thr result is ,,,fail...same no post if i try use any divider...

yeah, confirm is ram problem.

my ram hitting limit liow...have to change ram since it cannot rn on any divider ....end up no post,,,run on 1:1 is fine...run memtest,,stable..

3d mark 2005
3d mark 2003

cpu-z

i'm looking secondhand gskill 3200 fx..512x2 ddr400

This post has been edited by realone: Jan 3 2006, 08:08 PM

need help to improve my 3d score and overall system...

dude, it may also be ur bad proc memory controller
altho i didnt suffer prob luke urs, but my 133 devider is useless n 166 devider can only hold the ram till ddr500

but u didnt mention what test fails..
beside bad ram n bad mem. ctrl'r, psu also may cause the prob

as i state above ,before that when i run 256x2 kingston ddr400....its run fine and can use any divider,,,but after upgrade to 512 x2 ,,,,can't even run any divider,,,

so, its confirm ram problem,,,perhaps it dun like divider,, hehe

This post has been edited by realone: Jan 3 2006, 08:06 PM

newer version kingston value rams are unable to get you 240+ and above...but since you can run at 240 why not u try setting such as 2T 3-4-4-10 and use divider to drop ur ram to either 100 or 133mhz and then push again...just to see if your proc is limitating ur overclock....

ok, i will try

no post ...