Welcome Guest ( Log In | Register )

Bump Topic Topic Closed RSS Feed
79 Pages « < 73 74 75 76 77 > » Bottom

Outline · [ Standard ] · Linear+

 Short Review on the Exora Bold

views
     
taqu
post May 28 2012, 10:13 AM

Enthusiast
*****
Junior Member
864 posts

Joined: May 2005
My average FC is 11.6L/100km = 0.116L/km = RM0.23/km. Mix highway&kampung driving. Hard to keep my right foot alight smile.gif
zakinawi
post May 28 2012, 10:47 AM

Getting Started
**
Junior Member
82 posts

Joined: Apr 2006
From: Shah AlaRMM



mine is 12.1..abit high.. dunno why la..
SUSOptiplex330
post May 28 2012, 12:41 PM

10k Club
********
Senior Member
12,696 posts

Joined: Aug 2008
QUOTE(akchang @ May 27 2012, 11:53 PM)
let repharse that, what i did was went for my 1st 1k service @ mutiara damansara proton (i believe this is the official service center). when the SA check my car with a some kind of check list form, they mark "semi-sync" for me. I asked the SA i want synthetic only. then the SA said your bold is design for this type of oil "semi-sync". tats puzzle me. i still press on for synthetic oil then only the SA mark it for synthetic. Now i did not know what/which vicoscity at that time cause the checklist shows - mineral / semi -sync / synthetic.

when i saw the bill wat was being charged, then only i saw it was a syntium 1000 (15w-50). then i asked them why do you not carry syntium 3000? that's where they can't answer me. so im stuck with the oil right now and thinkin going out to get a syntium 3000 and do it out side for the oil change.
*
If manual says xW30 and they used 15W50, you have every right to ask them to drain the 15w50 and replace with xW30 with no charge to you. I know I would.

neo1point3
post May 28 2012, 01:15 PM

Getting Started
**
Junior Member
174 posts

Joined: Jan 2010


QUOTE(zakinawi @ May 28 2012, 10:47 AM)
mine is 12.1..abit high.. dunno why la..
*
How many km already? maybe you always rev rev till pass 3500rpm tongue.gif
Do u on SAT? i notice if i use sat, fc increases


zakinawi
post May 28 2012, 01:40 PM

Getting Started
**
Junior Member
82 posts

Joined: Apr 2006
From: Shah AlaRMM



13,000km, SAT not on. rpm never reach more than 3 coz city driving.. only sumtimes more than 3 coz drive highway for outstation
2die4
post May 28 2012, 01:59 PM

Getting Started
**
Junior Member
202 posts

Joined: Jan 2003


for me, best is RM0.17/km and worse RM0.23/km...

but normally at RM0.21/km...
Shah's
post May 28 2012, 02:12 PM

Getting Started
**
Junior Member
141 posts

Joined: Jan 2003
From: Gombak, KL


Mine average is .23/km (pure city driving)
this weekend only first time balik kampung with my Bold, and will update my FC.
BTW i refill RM90 (Full Tank) every week. Is it ok?
biosfree
post May 28 2012, 07:34 PM

Getting Started
**
Junior Member
182 posts

Joined: Jan 2008



NO need to talk about fc la..for me...x accurate, esp my road terrain here mostly hill .... for bandar2,...well...lagi la, sometime move sometime stop...so...fc is x accurate la...
R80
post May 29 2012, 11:24 AM

Getting Started
**
Junior Member
186 posts

Joined: Jan 2009

Added on May 29, 2012, 11:30 amguys...mind sharing the cost for servicing exora bold?

This post has been edited by R80: May 29 2012, 11:30 AM
ultramaman
post May 29 2012, 11:35 AM

Getting Started
**
Junior Member
168 posts

Joined: Jan 2010
From: 8.8.4.4



juz serviced 10k, changed oil, oil filter, coolant, check air filter.

153 bucks.

supposed to change air filter as well. since they no stock, and have to order and i no time to wait. so blow the air filter first lor.. later a bit i go change the air filter..

oil, im using 10-30 . petronas syntium 800. this is 10k service.
SUSOptiplex330
post May 29 2012, 01:35 PM

10k Club
********
Senior Member
12,696 posts

Joined: Aug 2008
I bet the original factory filled oil is Mineral 10W30. Anyone can confirm?

ultramaman
post May 29 2012, 02:06 PM

Getting Started
**
Junior Member
168 posts

Joined: Jan 2010
From: 8.8.4.4



QUOTE(Optiplex330 @ May 29 2012, 01:35 PM)
I bet the original factory filled oil is Mineral 10W30. Anyone can confirm?
*
i guess so, that is why im sticking to 10-30 for now. i got an fb pm from proton i care saying that 10-30 and 10-40 can be used. but im sticking to 10-30 . but one thing lah. 10-30 , is sooo thin... so post service, im adding revooil to it ( can buy from eneos , 28 bucks . ) i told my mechanic,, that some other centre poured 15-50, and he was quite shocked.



SUSOptiplex330
post May 29 2012, 02:33 PM

10k Club
********
Senior Member
12,696 posts

Joined: Aug 2008
QUOTE(ultramaman @ May 29 2012, 02:06 PM)
i guess so, that is why im sticking to 10-30 for now. i got an fb pm from proton i care saying that 10-30 and 10-40 can be used. but im sticking to 10-30 . but one thing lah. 10-30 , is sooo thin... so post service, im adding revooil to it ( can buy from eneos , 28 bucks . ) i told my mechanic,, that some other centre poured 15-50, and he was quite shocked.
*
Since Proton seems to have a deal with Petronas, then it's probably the Mach-5 10W30. I simply see no point using more expensive Semi or Fully Synthetic. It is like fitting a gold plated toilet in a Kampung hut.


ultramaman
post May 29 2012, 02:57 PM

Getting Started
**
Junior Member
168 posts

Joined: Jan 2010
From: 8.8.4.4



factory pour is only supposed to last 1k ma...
jemmi
post May 29 2012, 03:15 PM

Casual
***
Junior Member
485 posts

Joined: Mar 2009
QUOTE(cocodemon @ May 27 2012, 10:27 AM)
so what is the best viscosity for cfe? dun really understand this stuff

if their stock oil is not good, better bring my own oil for 1st service tomoro
*
New small engine normally my mechanic suggested 5-30 or 5-40, after 100,000km then change to 10-30 0r 10-40.
Normally I bring my owned Mobil 5-40 for service. Even my 1993 wira still feel smooth. Engine tip top but all other part 'goyang' already (macam nak tercabut). doh.gif
ultramaman
post May 29 2012, 03:31 PM

Getting Started
**
Junior Member
168 posts

Joined: Jan 2010
From: 8.8.4.4



QUOTE(jemmi @ May 29 2012, 03:15 PM)
New small engine normally my mechanic suggested 5-30 or 5-40, after 100,000km then change to 10-30 0r 10-40.
Normally I bring my owned Mobil 5-40 for service. Even my 1993 wira still feel smooth. Engine tip top but all other part 'goyang' already (macam nak tercabut).  doh.gif
*
well, while u still feel like wanting to claim for warranty... i would suggest to stick to service center oils. just make sure they pour the right type of oil. if you are not sure what type to use, you can either revert to what is stated in the book(10-30) or pour 10-40 . if you bring your own oil, they would jot it down in your service records, and if on a warranty claim, they might blame that since you brought your own engine oil, the warranty is void because the issue is caused by something related to engine oil. ( at least with the local car companies, i wont take my chances.... )

but yes, you can bring your own oil if your not comfortable with service center oils , or you can request the service center to pour some other oil. i know the one i go too, they carry petronas,shell and castrol. .
SUSOptiplex330
post May 29 2012, 03:37 PM

10k Club
********
Senior Member
12,696 posts

Joined: Aug 2008
QUOTE(jemmi @ May 29 2012, 03:15 PM)
New small engine normally my mechanic suggested 5-30 or 5-40, after 100,000km then change to 10-30 0r 10-40.
Normally I bring my owned Mobil 5-40 for service. Even my 1993 wira still feel smooth. Engine tip top but all other part 'goyang' already (macam nak tercabut).  doh.gif
*
Your mechanic is a very cautious person. But I don't think it is necessary to use Synthetic (5-30, 5-40) in the beginning and then revert to Mineral (10-30) later. In the old days, they actually warn against doing that. Not sure of nowadays.

ir5
post May 29 2012, 03:43 PM

New Member
*
Newbie
1 posts

Joined: Apr 2012


QUOTE(Optiplex330 @ May 29 2012, 03:37 PM)
Your mechanic is a very cautious person. But I don't think it is necessary to use Synthetic (5-30, 5-40) in the beginning and then revert to Mineral (10-30) later.  In the old days, they actually warn against doing that. Not sure of nowadays.
*
Guys,
Sorry a bit out of topic, but i've heard someone from outside saying that Exora Bold CFE:-

underpower - body besar...kalau naik genting nak tergelonsor ke belakang.
enjin kete 'manja'..takleh berendam dlm air even slight flash flood - terus jem (mati enjin)
sparepart susah dpt


any comments guys? coz i'm considering seriously to take exora bold cfe for my 2nd car...


SUSOptiplex330
post May 29 2012, 03:45 PM

10k Club
********
Senior Member
12,696 posts

Joined: Aug 2008
QUOTE(ir5 @ May 29 2012, 03:43 PM)
Guys,
Sorry a bit out of topic, but i've heard someone from outside saying that Exora Bold CFE:-

underpower - body besar...kalau naik genting nak tergelonsor ke belakang.
enjin kete 'manja'..takleh berendam dlm air even slight flash flood - terus jem (mati enjin)
sparepart susah dpt
any comments guys? coz i'm considering seriously to take exora bold cfe for my 2nd car...
*
You heard wrong. As far as engine power is concerned, the CPS is the lousy car your friend talked about. The CFE is a totally different kettle of fish and I think you should go test drive yourself. It's actually very nice to drive.



zakinawi
post May 29 2012, 03:46 PM

Getting Started
**
Junior Member
82 posts

Joined: Apr 2006
From: Shah AlaRMM



QUOTE(ir5 @ May 29 2012, 03:43 PM)
Guys,
Sorry a bit out of topic, but i've heard someone from outside saying that Exora Bold CFE:-

underpower - body besar...kalau naik genting nak tergelonsor ke belakang.
enjin kete 'manja'..takleh berendam dlm air even slight flash flood - terus jem (mati enjin)
sparepart susah dpt
any comments guys? coz i'm considering seriously to take exora bold cfe for my 2nd car...
*
bia betik... tak pnah dgr masalah masalah kamu di atas tu..

79 Pages « < 73 74 75 76 77 > » Top
Topic ClosedOptions
 

Change to:
| Lo-Fi Version
0.0211sec    0.68    6 queries    GZIP Disabled
Time is now: 3rd December 2025 - 06:18 PM