But it's kinda flawed in Malaysia since your car will be forever under heat and will just stay 1 color only

when u say my cat can tuka warna.... Mao damn piss off coz he thought that my meow meow can change colour HAHAHAHAHAHA

---

Added on December 25, 2011, 12:09 pmalways 1 colour until u go up to genting lols

This post has been edited by mxsteven: Dec 25 2011, 12:09 PM

No lah. At genting become 2 colour. Front and back diffent cause the engine at front is hot and the body top and back is cold.

Your pu$$y can change color ?

Wah steven u pakai chameleon paint ah? So got the capn slow decal done already?

This post has been edited by dares: Dec 25 2011, 03:28 PM

i want to flush my radiator...what do i need to do?i mean the proper way.

no lah i use Illusion effect paint only....but still cost a bomb

a running tap water... jk
although am no longer own a waja, basically its about the same for any car.
all you need is a radiator flushing material, sufficient coolant replacement, and running tap water.
you can remove the big hose connected from radiator (top) to the water pump / engine block for better
result. i usually do this after draining some water to accommodate the flushing material , start the engine and once the water pump running, let the tap water run through the radiator - block, until you see a clean water out.
once you're satisfied with the result, stop the engine, drain the radiator, put everything in place,
pour coolant inside- add water - full. start the engine, let it run for 10 minutes or so.
top up the radiator water when the water level drop.
don't forget to clean up / replace the coolant / water in the radiator reservoir too.

for some reason, i prefer distilled water over tap water.

This post has been edited by yngwie: Dec 25 2011, 04:56 PM

so i don't need to take out the drain nut under the radiator 1st?just remove the top hose?

You need to. After you fix the hose back. It's to bleed the air at the btm.

so let me repeat the steps...

1) prepare all items needed...
2) remove the top hose
3) prepare the running tap water..start the engine and let the water run until no more rust..
4) stop the engine.
5) remove the drain nut to drain the radiator.
6) fix the top hose and the drain nut back to its place.
7) pour the coolant inside the radiator. refill the water until full...
8) start the engine and let it run for 10minutes (or more)..
9) check the radiator water level and topup as necessary...
10) clean the container and replace the coolant for the container...

am i right?

---

Added on December 25, 2011, 9:57 pmradiator flush done.

This post has been edited by dinwaja: Dec 25 2011, 09:57 PM

Waja thread stuck eh? No one around on the holidays?

Everyone busy preparing for New Year and Xmas eh~

So sad, droped to third page ady this morning.

me also bz preparing for BOT 2.0 Project for CAMPRO and 4G18

BOT 2.0 <-- 300hp huhu

No lah... actually better lookin wan and more space....

sounds very interesting siap upload picture for us to droooooooooooooooollllll

Mana Mao (MM)

Damn, I need to redo my exhaust.....

Upload picture for wat.... install lah then only can feel.... u see only can masturbate lols

---

Added on December 27, 2011, 11:08 amlolssss MM is my company leh....

This post has been edited by mxsteven: Dec 27 2011, 11:08 AM

when want to do twin charger