ya..no need to use kies..

The reason why some of us want to try to rollsback to stock is because of current hardware issues or in the event of future issues , go to samsung malaysia and claim warranty. Of course if full hard brick then obviously can't roll back.
I think this situation applies to jhonsonlee since his tab has LCD screen issues.

As for kokifung, he hasn't got samsung malaysia warranty since he has AP set. So, no one knows why he must malaysianise his tab.

Hi, I'm not sure is this the right place or what...have anyone experience "no service error" using ur Tab? It is not sim card problem coz when I put the sim card in other phone it was OK.

Plus , is this battery problem? I've charged my tab 100% and suddenly it dropped to 5% , then I reboot my tab and it back to 70%.

Anyone?

so now what should i do?? i still remain at the froyo. DXJK2. but then my version is csc is P1000OLBJJ2

btw, fyi my tab is from sme..

why i cannot send sms ??

is it maxis problem or the table itself??

Are there anyway to flash M'sia Gingerbgead XME Rom via Odin and where can I download M'sia Gingerbread Rom?

Try here http://www.samfirmware.com/

I think should be under Asia with [DX].

This post has been edited by danieloo: Jun 30 2011, 11:51 AM

anyone facing problem with wi-fi? i cant connect after hard reset.

anyone know how to fix it?

Yo, new Tab-er reporting in. Wasup.

What's the recommended ext4 kernel to use for our GB version?

After flash the DXJK2 do the *#272*IMEI# then plug to Kies you should able the XME Gingetbread.

---

Added on June 30, 2011, 2:16 pmAfter flash the JK2 do the *#272*IMEI# install XME

then plug to Kies the new update will pop up for you to update the XME Gingetbread.

Good luck

This post has been edited by jhonsonlee: Jun 30 2011, 02:16 PM

i facing problem using samsung kies, even install the latest wan,still unable to my galaxy tab 7 inch with gingerbread version.
anyone has this problem?

Looking at the last few pages of posts, I always wondered why there is so much fascination with using Kies to update the Tab's firmware. I had thought that ODIN was a simpler tool for this with a higher success rate. Using ODIN, I have flashed European GB (P1000XXJMQ) and Malaysian GB (P1000DXJPC) without problems..

I've never installed or used Kies before, so maybe I will just keep wondering..

i able to use samsung kies update to gingerbread,just after update,got problem connect to samsung kies.hai...................

i never use kies and will never use it
it is just a bloated piece of crap. it is the worst sync software i have used. samsung should change tgeir whole team of guys behind it
krmdeva is right. use odin simple fast n efficient

Samsung just go hire team overcome to become a new android department of samsung

agree
and bring in more functionality and performance for the existing tab

Hi, i just bought gtab 3 weeks ago. I noticed that the battery drain fast. Mine, less than 20% left by noon. So, i was thinking to by a back up battery. I googled and found a few backup battery in the market. My question is, are they available in malaysia?

I need to use Kies because my Tab LCD flickering problem that's why I need it to flash back to XME.

Now I've successfully back to square one M'sia Xme Gingerbread.

Is the P1000DXJPC M'sia XME.

PDA: P1000DXJPD

Phone: P1000DXJPD

CSC: P1000OLBJPD

Wow i just kantoi'd my tab flashing using Odin 1.3. Must use 1.7 and pit from KM3 to JPD is it?

This post has been edited by Piccolo: Jun 30 2011, 06:07 PM

Yeah, if I remember correctly, I used Odin 1.7 with PIT to go up to JPC some weeks back. Wasn't too special compared to JQ1 which I also tried before. I've never heard of JPD firmware, though.

Now happily using Overcome 2.0.1 custom ROM.