i wanna ask, if i connect a router/switch to the lan port of the dir-615 to make extra port for lan or better wifi, is it ok, or is it doable? Becos my fren told me last time he connect a switch to 1 of the port of the router then can extend extra lan port. But tat is when he is using streamyx lar.

Is Caller ID really working? In my case initially was showing Private Number, after I called to activate CLIP it started showing "Out of Area". Now I am told they have a technical glitch that will only be resolved till end Setpember 10.

is our unifi password same as the wifi password tmnet given at 1st?

From day one of my installation, its been showing up as "Out of Area"

---

Added on August 26, 2010, 11:17 pmI'm guessing you are asking about your unifi password that is required for PPPoE process. Your password should be as what is indicated in the Registration Confirmation printout that came along with the TM guy who installed your setup

This post has been edited by richard912: Aug 26 2010, 11:17 PM

hmm I'm not living there yet. But I'll be moving there soon. Just wanted to know if there's anyone from Kuchai Lama and got Unifi installed ?

1. azri
2. PGGTrader
3. ldragon
4. Alex
5. Joe C (chungss)
6. Yushin
7. shahada -1
8. shahada -1
9. shahada -1
10. Paultantk
11. StanleYz
12. avex|mode
13. cafee
14. Jamil
15. Leong
16. Evirober
17. -pWs-
18. -pWs-
19. mox123
20. jchue73
21. auronthas

I will be away and only be back this coming Sunday, please pm me if any.

I've trying to setup wireless bridge connection for the iptv as follows:

RB250GS[LAN4] ----> [LAN]WHR-G300N <<<wireless>>> ASUS-RT-N12[LAN]-->IPTV STB

Both routers:
- are running on dd-wrt Aug2010 built
- wireless N-mode only at ch6 40mhz width, without any password
- firewall all off
- transmission rate ranging between 150~250Mb

The sound & remote control functions all ok no problem, but the picture image is still a bit jerk & lag every few seconds.
I tried to turn on & off WMM support but no difference....

Anything I've miss out? Hope some sifu out there can help!

This post has been edited by klseet: Aug 27 2010, 12:05 AM

Hey guys,

I've been using Unifi 20mbit for about a week now and am very unhappy with the crappy quality. The IPTV is also unwatchable. I'm definitely not paying for this crap.

What's the process to switch to 5mbit? (is there any lower package? I can't even get 5mbit with my supposed 20mbit package currently)

Thanks

i gt jus gt my unifi 5mbps yesterday.
so far so good.but the iptv sumtime lag a bit

i tried to use my buffalo ddwrt router thru the " Using the TMnet Dlink DIR-615 G1 as a VLAN bridge" guide, but how come when i speedtest, i only get like 0.8mbps 0.2mbps dl/ul?

anybody here know hw to use the d-link DIR-615 prt forwarding.
i wan port forward warcraft

Why your IPTV is "unwatchable"? Did you call to complain? May be it's a faulty unit?

Currently my IPTV connect through lan cable I didn't see any lag at all....

What Buffalo model are you using?

hmm i forgot edi lolz, but i just checked and i found out the QoS thingy is the culprit -.-... now can connect edi, thank God.. finally i am getting a better wifi.. altho no wireless N already..

i wanna ask, will there be any problem if i am using this setup? any pro or cons?

This post has been edited by ben3003: Aug 27 2010, 12:11 AM

sumtime onli,but i think the problem is with the QOS
haven really check it yet.

You can't downgrade without a penalty.
Please post your speedtest from the following site:
http://speedtest.tm.net.my

Any1 getting poor ping, jitter from pingtest.net I am getting poor connection. Not sure why my post is deleted yesterday about this ?

^unwatchable meaning constant blur / lines / etc. It was already like that when they fixed it. In fact, they changed the STB already. No difference.

They did speedtest with their laptop(s) connected via Ethernet and couldn't get good speeds either. Said there was some 'maintenance' going on....

Speedtest results :

IP range : 110.159.*

Down: 1512 kbps
(189 KB/sec)
Up: 2878 kbps
(359.8 KB/sec)

They told me I could downgrade... Hmm I have to pay extra now?

1. azri
2. PGGTrader
3. ldragon
4. Alex
5. Joe C (chungss)
6. Yushin
7. shahada -1
8. shahada -1
9. shahada -1
10. Paultantk
11. StanleYz
12. avex|mode
13. cafee
14. Jamil
15. Leong
16. Evirober
17. -pWs-
18. -pWs-
19. mox123
20. jchue73
21. auronthas
22. Mytown

Thanks

That's EXTREMELY bad for VIP20. How long has this been going on? I think you may be able to downgrade without a penalty if they can't fix your connection.
Did they check the fibre optic cable running from outside? Could be bended or something... where do you live btw?
I am still extremely happy with my connection, and I would still recommend people to get unifi.



The last time they told me they had this 'maintenance' going on my speed was double the above.
Free boost ended early this week though..

Hi all, am a new user to Unifi, currently able to setup my Belkin wireless N router to work along with the DIR 615 which is setup as a bridge thanks to Riz' guide.

Question on the Internet indicator (globe icon?) color when connected. Is it supposed to be orange/amber in color as opposed to the ethernet port's green color? Thanks for any advice yah!