i juz purchase the campro style center aircon outlet RM50, would it be expensive?....

Where did u get it from?

friend of mine gen2 timing belt broke off at 65K. So u decide.


This post has been edited by zenwarlord: Feb 9 2009, 08:07 PM

frm my fren...

try here...
http://z6.invisionfree.com/mjs/index.php?showforum=93

i am using Mintex m1144 for my rear disc
noisy use with r3 rear slotted disc

I can get it cheaper but sadly due to CPS model my supplier can't supply to me

?...y CPS model?...

My supplier is the main vendor for Proton..Now only can supply for CPS model n not entertain individual buyer

if not mistaken i bought it at RM35...

Hi guys i need some advice about Waja car. I'm planning to buy a used Waja car.Do you think a RM20,000 Waja is a good deal?

http://www.wemotor.com/?mod=browse&make=50...ce=20000&state=

Are u 1 of my customer

It's a good deal if u can find 1 in a good cond

a 2003 waja auto was listed for 20k too
TS, do check how much is the mileage covered and if possible, last service too.
auto transmission is a bit of worry when purchasing a used car. anyway, there are a lot of other thing to consider when buying a 2nd hand car.
ie;
good engine and gearbox condition.
no rust underneath / no leakage / no jerking / no vibration when idle.
make sure it is a proton not a 'potong' car. seriously
check the tires thread; uneven wear on the inner or outer thread indicates something wrong with alignment...etc....
test the brake in high speed. make sure the car stop in line.
no squeaking / minimal sound when cornering / going over bump.
electronic things all functioned.
check with relevant authorities too if there is an outstanding 'love letter'

just to list a few of em... btw, i bought my waja direct from the user at the end of last year.
everything was fine except the right side wiper loosened and it was so noisy.
minus the tool box too!

guys, any idea where can i buy the tools like those originally comes with the car?

---

Added on February 10, 2009, 10:56 amthanks zenwarlord. i found another stuff instead. poison...poison

This post has been edited by yngwie: Feb 10 2009, 10:56 AM

get urself a Stanley Rachet set (RM60) and u can get Mitsubishi tools from Halfcut shop. I got mine around RM20 only.

i'm back, anyway, anybody know price for a dummy rear wiper? its look cool

btw, my right side wiper is loosened. how to tighten it? possible for me to DIY it?
thanks again

Can adjust bro..there's a cover,open it then u'll see a nut

i planning to make a hole to install full funtional rear wiper but until today i still can't find shop can do that. My wiring and controller for rear wiper is all done.

---

Added on February 10, 2009, 12:56 pmyes u can DIY. Open up the cap on the wiper and tigthen it back, but before doing so, i suggest u to pull out the wiper and place it properly according to the track before tighten it. Mine also loose as the track is rounded.


This post has been edited by zenwarlord: Feb 10 2009, 12:56 PM

zen,where u get those rear wiper??but me wonderlah..coz how we gonna drill the rear windscreen??

i not yet brought the rear wiper motor, i only done the wiring when i do transplant earlier. So now i'm looking for shop that able to drille hole on glass.