kingston value ram, why?

i didnt overclock it , but today change my 8500gt ddr2 asus 256mb done these result



E2220 @stock
512MB DDR2 667
ASUS 8500GT DDR2
200GB HDD SATA2 Seagate

@next week i change to 9600GT test

Why you always want high score in Benchmarking? As long as you can get the best outta ur E2220 then it's good already..
If you really want high score.. Change processor to Quad Core and overclock it to the max ..

haha.....syiok what i guess

@calvinkli
bro your system memory is still very low. 512mb only. better upgrade that too when you get the 9600gt

Or else insufficient memory would bottleneck you.

@calvinkli
Well bro wats the point having a good card a min rams? Invest on some ballistix or something and bring out tho powah in your E2220
You will have enough boost to your GPU also

I m beginning 2 get irritated wit dis vdrop on my MoBo... Sumtimes during heavy load, my vcore will drop 4rom 1.57v-1.53v or below... N...BSOD will appear... Especially during startup... Is there anyway... dat we can usik2 dat voltage drop???

Better cooling

My motherboard also cacat .. sometimes 1.472v straight all the way stable.. Then sometimes drop till 1.457v ..

Must vdroop mod it but don't know how ..

He already using WC .. Means have to get Dry Ice already ..

Nah... I think Air Cooling works better in Malaysia~

Water Cooling is better than Air Cooling

@Amedion
Can mod eh??? Gud2... I'll go n check out in Google... But surely its dangerous 2 mod it rite??? I mean if wrongly done afraid it might KABOOM N using DICE??? Aiyoo... I pokai later on...

@Silverfire
Cooling is da problem dat causes voltage drop izzit???
Ok laa... comparing wit my cheap water cooling set, of course air cooling is better.... Unless if I upgrade my WC parts wit a better 1...

No.Vdrop is to protect your mobo and your processor. IP35E have pencil mod to lessen vdrop to .02 or so

Sifus here i m backed again..tis time with "lagi" strange problem..since i haven give up with my ram i try putting them running on single channel can boot like normal and normally load into window..change back to dual channel mode the same problem occur again..my computer keep restarting ..WTH is happening?i really run out of idea

Vdrop/Vdroop also caused by heat which decreases stability and movements of electrons in the digital circuits.

Vdrop is basically a mechanism promoted by intel to reduce the sudden surge of voltage when a processor goes on load. The Vdroop is higher when in full stress if u notice, not because of heat but because of the load that it experiences and the higher the voltage you pump, the bigger the Vdroop is, simple law of balancing. Vdrop/droop is a good thing in fact for the health of the processor. ONly that it affects us all, overclockers coz we want every inch of juice we can get.

Abit IP35-E has a bigger vdroop on higher Vcore. Which is totally normal for mid-end 4-phase motherboards. If u do circuit mods on the lga775 built to the board, not only u lose a mechanism to save your proc, in case of a sudden surge of load, but also burn the proc in an instant.

More info on vdroop:
http://www.thetechrepository.com/showthread.php?t=126

Shoot.... well then, juz hav 2 bear wit it....

Consider Foxconn Mars then

Hi Guys..noob entry here..
me manage to O/C my E2160 to 3.30G only
This my spec.
E2160 L2 Stepping wif Silverstone NTO2
Abit AW9D-MAX
Kingston DDR2 667 2 X1G Hynix FPY5
HDD 160G
Cooler master igreen 600watt

my temp seems not so good..
edy apply Tuniq-TX2 to all NB,SB Heatsink and mosfat Heatsink.
btw..its cooler than my proc wif stock cooler
any advices