ok i run the linX and it only stable for about 4 loops and the temperature hit 90C before the comp auto restart
but it stable with the prime95 for 2 hours with average temp 75C . I dont know which couse the restart, voltage not ungh or temp to high ?

Linx more stressful than Prime95.

-pWs-

the heat really the problem for clocking up the kentsfield' zzzZzz
itchy to oc back, but no gears to cool it down

btw, guys... once ur cpu temp. reaching 7x-8x C'
i wonder what's ur nb temp.? , since it's close enough to hsf.

if i have xtra proc lying around, or im rich enough to buy another proc, y not?
btw, how u lap?? self lap or go shop do? @@

ok here it is.
10 loops of linx and it still stable with a 90C,but the temp getting 90C max, im afraid it gonna burn my processor, but i usually get 60-65C on load while playing games 24/7. Guys, should i lower my FSB ? or is it ok with this setting ?




This post has been edited by hobby69: Nov 23 2008, 08:40 PM

59 degree

-pWs-

Correct

I dont have hsf

But i put a low cfm 8cm to circulate the air, vnb 1.27v load 51c now

Its ok, just leave it that way.

thnks

Wuuuu.....

nice mirror finish...

cant resist...

How you hold the processor when lapping becos the proc chip is small, n any risk that may contact the other side of the chip, secondly it seem very hard to hold it. Did you use anything to hold it when u do lapping.

yes, please lap and update us with pics !!! my fan are noisy !!! but already got used to it !!!

AC MX-2, will post some pics later

use 2000Grit ! bro verdict, u can do it !

Bro Dickong, remember the small little black plastic that come together with the Proc? it should cover the underside of the contacts during lapping. Even force should be applied to the proc while lapping to avoid uneven surface !

enjoy !

I just lap my processor but i am only getting about 3c different, is it i have apply too much as5 on it, i apply small amount on the proc n small amount on the heatsink, is it alright. secondly why small difference only.

you must apply it in a proper direction ! HORIZONTAL for QUAD CORE, and VERTICAL for DUO CORE !

Presently doing 3.4g after lap my true n prc @ 1.4v before 3.2 @1.325. Question is i need to pump in so much exta voltage to get 3.4g stable secondly i am getting the same temp as before for 3.4g compare my previous 3.2g, thats means to show there is improvement on the lappng but still not satified becos getting around 61-60-55-52 full load for more than one hour, whereas i see some forerummer getting below 55c n higher proc voltage, any ideal why.

So by lapping the proc, we can get around 3-5c temp diff under load eh

It could be the ambient temp and other factors too that makes the temperature different from 1 setup to another.

Improve of 5-6c after lapping but still my Q6600 @ 3.4g voltage @1.4 only but temp seem a bit high at 61-60-55-52c full load. Is it possible that applying too much of AS5 can be the cause of high temp.

don't apply too much, just follow the pic above

Try google:TRUE washer mod,can drop some temp as well

hey OC4/3, fror TRUE MOD got 3:
1. TRUE washer mod
2. Backplate Card mod
3. Bolt through mod

but pls beware, excessive pressure and stress will break the internal PCB layers of your BOARD

Danger !

Still acceptable, dont worry