Yes, all fuel injection car do have throttle body

Suggest u to

Clean throttle body & intake manifold
Replace air filter
Clean fuel injector
Fuel filter?
New Spark plug?

power...
pdt tuning
knn drop in filter
denso iridium plug
liqui moly or torco or royal purple engine oil
change to lighten campulley n crankpulley
change extractor n full stainless steel piping with same diameter size n cat back exhaust
use higher octane fuel

safety...
ultra racing complete bar
stainless steel braided hose
use eagle f1 asy 2 or ps3 or re003

extreme power with extra safety
lighten camshaft
remove weight
aftermarket ecu
rollcage
aftermarket engine piston
bigger injector
bigger disc slot n piston
bolt on turbo
n more..

hope this help
price may vary from cap ayam to original.tq

This post has been edited by lowprofile: Jun 15 2015, 10:53 AM

recently, i went to tyre shop for balancing and allignment....

the shop informed me that my front disk already bengkok..but i didn't feel any different...

Do you guys experienced the same? Kindly share....

Also, checking..dunlop tyres is it OK?


Thanks.

go to shops that can do skimming first. they should be able to advice. but if you skim the disk, replace the pad as well.

bro zaidi...
u means skinning? like making the contact surface shine again?

RM60 per side right?

it is ok if you don't feel any wrong with the brake disc
what model of dunlop you mean?

skim. like http://www.mudah.my/Disc+Brake+Skim-22411377.htm

for CVT it's not adviceable to do on wheel skim, make sure they remove the rotor and spin it on the machine and not using the car engine.

i change to this cheap tyres. SILVERDOLF RX-201. malaysian made, licence by TOYO. RM245/pcs. harder side wall compared to the indon stock tyres. do alignment and adjust front chamber. feels much better now, even at high speed (free hand for a few second at >160KM/hrs). no more pulling to the left side.

This post has been edited by tehsarbat: Jun 15 2015, 11:46 PM

I change to new tyre Falken @rm240/pcs and allignment @rm25 at Dengkil, feel more comfort now

Formula D05? how much per piece?

Thks for the feedback and advice, however my friend just wish to regain the earlier / original power instead of super boot up.

ANybody any idea in Penang any known foreman to do this, beside Proton SC? Since his car not longer under warranty.

no problem..
top engine overhaul & full stock exhaust replacement
should be gain original power again

Try asking/finding for tyre Goodyear EfficentGrip Performance but not available. Change to Yokohama CDrive2, feel comfort & good performance like Michelin PilotSport3.

how much bro per piece? which area? kl/sel?

Installed a UR Front strut bar, handling on corner improved immediately! Thinking of installing rear anti-roll bar, any advise sifus?

Yokohama CDrive 2 for 225/50/17 RM360 each, I order another set size 195/55/15 RM185 each. I think for size 205/55/16 around RM250+
My Location Klang, Selangor

Cdrive if 250+ is really a bargain for 205/55/16.
Another option is Toyo NE3, I think around 270, Bandar Baru Bangi.

But still I prefer Michelin 3st, around 350 at Puchong.

--no one replied--

This post has been edited by alexei: Jun 23 2015, 09:54 AM

Just did 30k service. apparently every 30k need to do major aircond service to vacuum and replace new air

Actually my main target is Michelin Primacy3st but too soft & fast finish(treadwear) & Goodyear F1 Assymetric2 but only produce for low profile(45 & below).
Other target Goodyaer EfficientGrip Performance(Famous in Europe) but not available locally.
Also using Michelin PS3 but higher price than CDrive2.