QUOTE(Quazacolt @ Dec 2 2012, 03:43 AM)
front don't care at the moment since i'm also on PU bushings, dunno what brand though but it's still holding up well so that's that.
it's the rear axles that i'm not sure how the stock rubber (or maybe they are PU? no idea never really ask/inspect lol)
importing around january since the detailing stuff (eg: meguiar's) locally are overpriced to hell lol.
if just wash (not wash and wax, those are better once you've done a complete detailing session that includes proper claying/polishing and waxing lol) i can recommend turtlewax f21 car wash. very lubricating and does a pretty good job at washing off dirt. it doesn't cost an arm/leg too at ~rm25-30ish per large bottle
http://www.turtlewax.com/detail-F21%20Car%20Wash-9-111.aspx
Added on December 2, 2012, 3:50 amhttp://en.wikipedia.org/wiki/Polyurethaneyes they last longer than rubber, synthetic based after all
if your sound is more apparent during turning, then most likely it is the drive shaft/cv joint.
considering the sound is also present (since you didn't say no sound, only higher when turning) during straights, i'd recommend replacing the entire drive shaft for both sides, expensive, however less headaches that way.
well im not too keen on bendix fronts considering the materials used. my current rapid stop is headache as it is in regards to brake dust haha.
best if you can identify where the sound is actually coming from instead of troubleshooting blindly

if you're looking for kent then you can explain to him and he can help you troubleshoot.
ooo..turtle? ok

let me finish off ONR 1st...

d optimum wax is nice,but ONR IMHO its more suitable to those wash car weekly...those wash 2weeks once, not really suitable...d cleanin power isnt really there..
QUOTE(ken_ng @ Dec 3 2012, 09:39 AM)
haha...how cheap?

Added on December 3, 2012, 9:41 amya manual. the LMSS(special edition) has sportrim, skirt, bigger exhaust which are all original for this version.
lol....cheap till u scream.. how much u act lookin at?
Added on December 4, 2012, 8:20 pmQUOTE(evolution120 @ Dec 3 2012, 08:04 PM)
how much is replacing whole driveshaft lol.. but replacing the axle and changing the axle seems cost a lot though.
is the rapid stop good? i saw plenty of positive review about it too. used to have dilemma on getting the bendix or RS

driveshaft depends on half cut / recond/china new. usual roughly rm1xx perside. somemore need do allignment also after dat. gear oil also need top up/change
rapid stop is good for normal road/less corner track. quazo told me its heavy dust. in youtube, some said its bite BUT will fade after few downhill corner at genting. m usin bendix ultimate, it feels more like stock, but onli show its strength when u hard brake. each also got dust but guess its less than rapid stop.
This post has been edited by low yat 82: Dec 4 2012, 08:20 PM