hmm .. I never like to use WC due to hassle installation progress ...

too damn lazy and doing cable management with WC system is a dangerous activity.

Must get it done right for once ....

haha ... unless u are willing to paid it's shipment from UK to MY ...

juz remounted, temp still the same, thermal paste seems spread around nicely... wondering the problem, btw, high vcore can cause such huge thermal increase?

If the price totals up to be less than buying a new 1 here shud b fine ...

Did you touch the water? Is it hot?

the water is warm.... loop no problem, vga delta of 4c only... juz check swiftech temp calculator, guess what? the temp is normal after i key in the freq, ambient and vcore... so no worry for me i think...

ur vga also connected together?...

seperate loop, dual loop for nw... but i go swiftech website compare the load temps... select the compact 220 there got 1 temp calc, my temp are cooler a bit compare to tht kit using calc, so i guess is normal since i running 1.5vcore... 1.472v in windows...

muahahahaha...

now officially i get Swiftech mcp 655 pump and Swiftech res micro..

But mobo still dun get ...

I think there is nothing wrong with that.. I think most of those low end proc is hotter. Haha.. My celeron 420 recorded 40'C Idle under my WC and aircond. While my E8400 idle is around 22'C only.

ya also... i been remounting it few time, checked the thermalpaste, it seems spread nicely... high probability its hot proc for my proc... lol...

@doom,
haha, i am suffering major cable management headache after done dual loop inside my stacker... nw all the cacings hard to tied up as hands also hard to get into the case... all the tubes around... LOL

This post has been edited by lichyetan: Jan 7 2008, 11:04 PM

hahah .. that's the problem with water cooling tubes ... it's like additional cables to manage ... and it's so inflexible as well ..

btw officially retiring all my wc kit ... hahah back to air cooling ..

e2140 so hot meh ?? didnt notice that , i tot quad core is the hottest dude around............

btw lichyetan, show ur new setup, like to see how blitz looks in action hehe......

Doom so what next ? sigmatek ?

quad core is hotter, if oc'ed heavily load temp shall around 60c+ also, according to xtremeforum on those foreigner on apogee gt with heavyly clocked q6600... mine stepping not so good la, 3.2ghz need 1.55v... which is crazy i think or is it ok? 1st time oc intel proc... haha... now running 3.12 stress test using prime95 for both core on 100% load... 1.5vcore now, load temps =53-55(core temp)

put everything external then ur system will be nice and neat... haha

Pics is uploaded... here is the link:
http://forum.lowyat.net/topic/41021/+399

Getting closer....

My E2140 is just as hot. Load temps can be 64C even on IFX-14 but I'm putting in 1.5Vcore

this prove my wc is working as i worried cause load temp are 55c on 1.525vcore. i am on ambient of 30c...

Something that i would like to share with you guys. Last time i was using Eheim 1048 and i changed to Swiftech MCP 650 and i dont get any diff in temps where people suggested pumps with high pressure and flow to be used with this Storm G4 so that there would be some decrease in temps.

Btw im not running it at full speed as i put the speed controller at 4/5 which run less than 12v.

Makes sense to me since you're about 10C lower with water. I guess those chips are just simply too hot.