Mitsubishi electric starmex loh.
More quiet for indoor fan DB & outdoor size is bigger = more faster cooling.

If compare the input watt for starmex is the lower than other brand.

One more thing starmex got easy clean design to access into fan blower to clean on blower blade easily.

Just imaging on stand fan after 3 months of usage can see a lot of dust stick on fan blade.

Does all mitsubishi air-con is mitsubishi starmex?

You can check in melco malaysia website

checked but it didnot mentioned starmex

I also checked with one of the electrical shop nearby my area. When i asked the boss about Mitsubishi Starmex, she didn't know the model and said there is only "Mr. Slim" model Mitsubishi.

Refer here : http://www.mitsubishielectricmalaysia.com/...ircond/inverter

Refer here http://www.mitsubishielectricmalaysia.com/...ircond/inverter

thanks for the informative info
is SRK 10YLS model = starmex?

Look ur is heavy industrial model

the air goes in from the top grille of the blower through the air filter then to the louvre.

the air filter and the cooling fins already act as a dust collector.

the louvre section is normally less dusty (my case is 6months using still nothing on the louvre surface) than the air filter and the cooling fins (or the rotor)

if the louvre part is dusty, i believe the air filter + the cooling fins are already covered by the dust.

if the easy clean feature falls on the cooling fins, then we can save cost on engaging the aircond people to clean the aircond.

unlike stand fan or table fan, the air goes in from the rear side to the front side. there is nothing to filter the air. so the blade is easily covered by the dust than aircond louvre.

Just simple search my previous posted.
Had meantion about using extra filter.

Seriously will the extra filter affect the system or not?

Thanks kimsim.

May i know which particular model is referring to "Starmex"? Noob here.

So far so good.. Happy for usage. Already 3 more years now..

How bout ur car cabin filter?

This post has been edited by kimsim: Oct 21 2013, 03:53 PM

Here you go :



This post has been edited by kimsim: Oct 21 2013, 06:58 PM

I plan to install 1hp for my dining hall, 1.5 hp for Living Hall, 1.5hp for Master room and 1hp for guestroom.

I going for non-Inverter due to budget and to change copper piping cost a lot.

Would like advice, which brand is good for Non-Inverter?

How much is non inverter 1.5hp you're getting?

Not getting any yet as I not sure which brand to go for.

How bout York non-inverter?

Recommended to install Mitsu Mr. Slim..

Been using one since 2009 in my son's room..

Damn cooling with 1HP....

Planning to install one more at the other room & found the price dropped RM850 with installation but shop told me there will be 15% increase soon...