Hello, i just got my D-Link AC1200.
May i know how to setup DVR (CCTV). Which one should i set virtual server or port forwarding?
Thank you
D-Link Malaysia Official Thread
D-Link Malaysia Official Thread
|
|
Oct 29 2018, 01:48 PM
|
![]() ![]()
Junior Member
260 posts Joined: Jul 2008 |
Hello, i just got my D-Link AC1200.
May i know how to setup DVR (CCTV). Which one should i set virtual server or port forwarding? Thank you |
|
|
|
|
|
Oct 29 2018, 07:49 PM
Show posts by this member only | IPv6 | Post
#222
|
![]() ![]() ![]() ![]() ![]()
Junior Member
864 posts Joined: May 2005 |
|
|
|
Oct 31 2018, 04:26 PM
|
![]() ![]()
Junior Member
67 posts Joined: Oct 2017 |
|
|
|
Oct 31 2018, 04:30 PM
|
![]() ![]()
Junior Member
67 posts Joined: Oct 2017 |
QUOTE(broken_heart @ Oct 29 2018, 01:48 PM) Hello, i just got my D-Link AC1200. You can follow this page on D-Link May i know how to setup DVR (CCTV). Which one should i set virtual server or port forwarding? Thank you https://www.dlink.com.sg/dir-842/ [56840] DIR-842 – How to configure Port Forwarding Multi ports.? [56838] DIR-842 – How to configure Port Forwarding? This post has been edited by D-Link: Oct 31 2018, 04:30 PM |
|
|
Oct 31 2018, 08:44 PM
Show posts by this member only | IPv6 | Post
#225
|
![]()
Newbie
10 posts Joined: Oct 2018 |
Hi, i just bought DIR 882 for unifi turbo 500Mbs. Currently i stay at double storey house. Can i know suggested repeater for me to buy to extend my wifi coverage in mode 5Ghz. Thank you.
|
|
|
Oct 31 2018, 09:07 PM
|
![]() ![]() ![]() ![]() ![]() ![]() ![]()
Senior Member
5,714 posts Joined: Mar 2007 |
|
|
|
|
|
|
Nov 1 2018, 08:18 AM
Show posts by this member only | IPv6 | Post
#227
|
![]()
Newbie
10 posts Joined: Oct 2018 |
I buy DIR 882 and finish setup for unifi. Result of my speedtest on mode 5Ghz around 300Mbps (ok for me). After firmware update, i found that speedtest result on mode 5Ghz only not more than 70Mbps.
Because of that, i decided to restore to factory setting, i have can't setting for VLAN. Can anyone help me how to solve this problem. I also try to downgrade firmware but failed. This post has been edited by scorpenez: Nov 1 2018, 08:18 AM Attached thumbnail(s) |
|
|
Nov 1 2018, 03:45 PM
|
![]()
Newbie
10 posts Joined: Oct 2018 |
Problem solved when i try using other browser.
Current situation: 1. Wifi on mode 5Ghz can archive around 300Mbps. 2. LAN connection only result below 70Mbps. Before this i'm able to get speed around 500Mbps using old router from unifi (DIR 850). Anyone can help me? |
|
|
Nov 2 2018, 10:43 AM
|
![]() ![]() ![]() ![]() ![]() ![]() ![]()
Senior Member
5,252 posts Joined: Jan 2003 From: Apple MACland |
Question for those that are owning the DIR-882. Are you guys able to get the schedule to function properly? The unit my friend is using does not seem to work when all the rules are set correctly, the WiFi still stays on.
|
|
|
Nov 13 2018, 10:19 PM
|
![]() ![]()
Junior Member
72 posts Joined: Mar 2012 |
got my DIR 882 from TIME. But it seems like the wireless connection keep disconnected every 15 to 20 min. Its annoying even though it auto reconnects back. Please advice is it anything to do with the firmware? Current firmware is 3.5.8TT. Please advice
|
|
|
Nov 14 2018, 06:15 PM
|
![]() ![]() ![]() ![]() ![]() ![]()
Senior Member
1,731 posts Joined: Jan 2007 |
QUOTE(jasonchan323 @ Nov 13 2018, 10:19 PM) got my DIR 882 from TIME. But it seems like the wireless connection keep disconnected every 15 to 20 min. Its annoying even though it auto reconnects back. Please advice is it anything to do with the firmware? Current firmware is 3.5.8TT. Please advice WEP or WPA2 ? Or maybe is overheating. |
|
|
Nov 14 2018, 06:32 PM
|
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]()
All Stars
24,467 posts Joined: Nov 2010 |
QUOTE(D-Link @ Oct 31 2018, 04:30 PM) You can follow this page on D-Link Hi,https://www.dlink.com.sg/dir-842/ [56840] DIR-842 – How to configure Port Forwarding Multi ports.? [56838] DIR-842 – How to configure Port Forwarding? Like to check with u... dlink dir842, can it be used as a repeater? I couldnt find it in the router UI. Thanks. |
|
|
Nov 15 2018, 09:37 PM
|
![]() ![]() ![]() ![]() ![]() ![]()
Senior Member
1,144 posts Joined: Jan 2006 |
Hi,
I just bought Dlink DR825+ and set it up with Unifi. I am experiencing frequent disconnection issue where Unifi connection will drop after ~10 minutes. Then I am not able to connect again unless I reboot the router or modem. It will then re-connect before disconnecting after 10 mins or so. It is not Unifi/modem issue as my connection is fine with my old router. Wifi and LAN both working fine. I suspect it is setting issue. I am following the guide from the link below for setup. Is there anything extra need to be done? https://www.dlink.com.sg/wp-content/uploads..._Setup_Card.pdf |
|
|
|
|
|
Nov 15 2018, 11:20 PM
|
![]() ![]() ![]() ![]() ![]()
Junior Member
864 posts Joined: May 2005 |
New D-Link DIR-868L reporting in.
I believe this is an underrated router bcoz it's old and tabung-shaped similar to its ugly sister DIR-850L, but it's the cheapest AC1750 router today. Even cheaper than Tenda AC15 (AC1900) with nearly similar performance. Limited units though. I didn't setup it as a router (already using TP-Link C1200 for that), only as wired AP to cover ground floor. |
|
|
Nov 19 2018, 01:08 AM
|
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]()
All Stars
24,467 posts Joined: Nov 2010 |
D LINK rep no more here to take questions?
|
|
|
Nov 20 2018, 08:07 PM
Show posts by this member only | IPv6 | Post
#236
|
![]() ![]()
Junior Member
185 posts Joined: Dec 2008 From: Puchong |
anyone using DIR-842 C1 TM router??
have you got problem only “Connected client: 48” than mean only 48 device can connect. more than will cannot get DHCP ip and can't internet |
|
|
Nov 20 2018, 10:05 PM
|
![]() ![]() ![]() ![]() ![]() ![]() ![]()
Senior Member
5,714 posts Joined: Mar 2007 |
QUOTE(delaciox @ Nov 20 2018, 08:07 PM) anyone using DIR-842 C1 TM router?? Just adjust the DHCP scope to be wider. Anyway, if you have more than 48 clients, time to get a new better router.have you got problem only “Connected client: 48” than mean only 48 device can connect. more than will cannot get DHCP ip and can't internet |
|
|
Nov 20 2018, 10:05 PM
|
![]() ![]() ![]() ![]() ![]() ![]() ![]()
Senior Member
5,714 posts Joined: Mar 2007 |
QUOTE(delaciox @ Nov 20 2018, 08:07 PM) anyone using DIR-842 C1 TM router?? Just adjust the DHCP scope to be wider. Anyway, if you have more than 48 clients, time to get a new better router.have you got problem only “Connected client: 48” than mean only 48 device can connect. more than will cannot get DHCP ip and can't internet |
|
|
Nov 21 2018, 12:01 AM
Show posts by this member only | IPv6 | Post
#239
|
![]() ![]()
Junior Member
115 posts Joined: May 2005 From: どこかなあ |
hi, i just got a DIR882 this morning, after setting up with my Unifi , i find that it reboots itself every now and then, sometimes about half an hour , sometimes an hour or 2. so i upgraded its firmware to the latest, still happening. tried other stuffs such as disabling the smart connect, doesn't help either.
anything else i can do? other than waiting for the d-link support to reply my email, that is. |
|
|
Dec 7 2018, 06:17 PM
|
![]() ![]()
Junior Member
67 posts Joined: Oct 2017 |
QUOTE(cryspower @ Nov 21 2018, 12:01 AM) hi, i just got a DIR882 this morning, after setting up with my Unifi , i find that it reboots itself every now and then, sometimes about half an hour , sometimes an hour or 2. so i upgraded its firmware to the latest, still happening. tried other stuffs such as disabling the smart connect, doesn't help either. We will Pm you please reply us.anything else i can do? other than waiting for the d-link support to reply my email, that is. Thank You |
| Change to: | 0.0384sec
0.86
6 queries
GZIP Disabled
Time is now: 16th December 2025 - 03:09 AM |