I recently changed to Foxconn Mars mobo... What are these Temp1,2,3,etc...?




This post has been edited by IcEMoCHa: Dec 22 2007, 03:42 PM

my cpu temp idle at 35C..core 1 at 47 and core 2 at 48.,is this normal temp for core 2 duo 6300.,i run at default speed 1.86GHZ..

yep..it's pretty normal for your core2.

What cooler and Mobo are you using?

i'm using TR ultra 90.,with just cooler 9cm fan.,and gigabyte p35-ds3 mobo..is that ok?

---

Added on December 24, 2007, 2:08 pmlast time i'm using as5.,the temp is around idle 35C core 1 37C core 2 38C.,but when i switch to ac mx-2 the temp idle 38C core 1 49C core 2 50C..so i moved back to as5.,but not improved at all..

This post has been edited by Jibek: Dec 24 2007, 02:08 PM

i have a question here
AMD 3500 with HR-01
idle temp - 42C
load temp - 50C
with full- close case.

is this consider as normal or not?

its normal..

Idle is fine n load is also fine... Ur load, r u running full load???

@serez

Do u run it passively or with a fan ..... HR-01 works well with just a low RPM fan that pushed least amount of air...

I used to use it with stock E6600 with a 12cm fan that runs about 700RPM with temperature idle at 35c load at 48c ...

Even if it's equipped with high CFM fan the result may not be promising at all ..

Good evening guys. I humbly seek ur opinion about my chassis fan setup. Rite now, when my case is closed, the cpu temp is ~60'C both cores. With side panel opened, the temp dropped to ~53'C both cores. I guess the air circulation in my chassis sucks . Here's what I'm thinking about:


So.. What do u guys think?

Here's my current CM690 fan setup: Rear and top is exaust, front and side is the intake, bottom (none), all coolermaster stock fans.

This post has been edited by zubai: Jan 3 2008, 11:11 PM

Not bad...

I would humbly recommend u to get a replacement cooler for better OC ..

as well as keeping temperature low as it could ....

That's not my P5N-E SLi, haven't fitted it yet . I'm going to change to TT Big Typhoon VX, psu, and replace the mobo with P5N-E SLi (still in the box).

Is it possible for the processor temps to be lower than the ambient temp during the same time of observation using air cooling?

Nope... How can the cpu temp lower than the ambient temp that u use to cool the heatsink?

I came across a review of an active air-cooling heatsink that has a reported CPU core temps lower than ambient.

wat i usually do to find out temps in speedfan is ...

1/ install the mobo's monitoring software
2/ open both mobo's software and speedfan....
3/ load cpu and see which one matches.

works everytime

mobo monitoring software only shows 3 temps ... CPU, System and NB... lol

thats all u need wat....the rest is just rubbish wan....

find out which is ur cpu...which is ur system and which is ur NB lor...

to find out individual core temps its already there mah Core 0 and Core 1

HD is obviously ur HDD... if u wanna find out which one...check the SMART tab and also check the "CHIP" under temps config

i see... thanks...

http://www.zerotherm.net/eng/product/NV120p.asp

i just bought this cooler from sim lim square yesterday. I would like to consult from you all experienced overclocker if the temp i'm having is reasonable for this upgrade.

details:-
intel pentium dual core E2160@3Ghz, vcore 1.45, stepping m0 (333X9)
pc5300 2gb dual channel running at 333mhz, multiplier 2.0
ga-p35-ds3p

stock cooler idle temp is at 45c and full load is at 70c.

after upgrade temp i'm getting at idle is 36c, full load is at 65c. if the product is suppose to be doing better, i may think of lapping on the base cooler to give it another try.