r22 still can be used till 2030. r22 cheaper and stable

Once the volume is lesser than R410a, that meant the final stock of R22 will be increase price lah.

Because I hear from ppl that my new condo's aircond piping cannot support inverter type. I still need to verify as key not collected yet.

new condo now give aircon or air con piping is normally non-inverter type as they wanna save cost.. better ask developer to confirm 1st

any idea on the electricity consumption for 1.0hp wall mounted aircond and 1.0hp ceiling aircond (cassette type)? Is it recommended to install ceiling aircond? I was thinking that the coverage of ceiling aircond is better. Planning to install for living room and master bedroom. Any recommendation? Thanks@

Just depend on brands and power input watts.

1hp is don't have any brand offer below 1.5hp of cassette type.

Cassatte type will be high maintenace, like water drain pump not working or chemical wash for worst condition.

Actual like Pana or Daikin or ME cassette type, if the lower price may Daikin GA will do.

Hi,

Noobies with question here.

What can I do, if I want to install aircond on my living room and only limited to there; since my living room is directly connected to dining hall and kitchen?

Any question?

This is very common for sharing compartment right.

Just install face to living sofa area will do.
But would be take time for cooling down only.

Getting new air-conds for my apartment. Now I'm deep in the R22 vs R410a debate.

The air-cond installer seems to be discouraging the installation of R410a units due to the higher service costs and units that break down more easily.

Anyone here know how much more expensive it is to service R410a non-inverter units and if it really breaks down more frequently?

Thanks.

This post has been edited by thesoothsayer: Jul 20 2015, 11:42 PM

How come Malaysian midset is always thinking R410a is an expansive maintenance?

They is no such thing on higher maintenance at all, from R22 to R410a both needs to maintenace and serving for clean out dust also.

Unless is gas leakage due to poor installation.

Nowadays all Aircons brand has been runing R410a gas already, from R22 gas will be shortage in future for sure the gas R22 price would be go up again, then baru complain why not get R410a in the 1st place.

R410a inverter or non inverter in the 1st place of the gas pressure are higher than R22, even turn on duration of the temperature reaching time also much faster than R22 as lower pressure.

For power energy from R410a will be much energy efficient too.

This post has been edited by kimsim: Jul 20 2015, 11:54 PM

Not sure you guys can get it pure copper wire in malaysia market?
In SG hardware can get it anywhere

Why not you run an element test and see what is inside
If really 100% pure copper I don't mind pay you 1000 to buy it

In Sg just selling $26 for 30m long only

As said, run the test first. SGD26 or rm26 I don't bother

You meant they can cheat?

Why no confident?

3x70 is quite thick Leh.. How to break?

This post has been edited by kimsim: Jul 21 2015, 09:15 AM

As said, do the test first before boasting on this shit again

Even test n run in condenser with high power load also won't be break as fast wow..

Finally installed 2.5hp and 1.5hp pana inverters today replacing my 4yr okd Daikins. Hopefully all ok and got some money saved..

Hows the 2.5hp Panasonic inverter doing so far? Is it good? Is yours the CSS-24RKH-1 model?

Planning to change my master bedroom aircond too.

17' width x 22' length x 10' height, according to HP calculator i need a 2.5hp aircon.

cheers!

Hi guys, I'm planning to get Daikin 1.5hp inverter. Is there any good deal around plus installation? Location Kepong. Thanks.