can maxis VoIP split to 2? If yes, one single rj11 splitter is sufficient?

As in use 2 phones from one port? If yes then can be done. I'm doing that right now.

yes, mind to share how you do it? uses a rj11 splitter?

Yes that is right, just use a rj11 splitter and it's good.

alright, thanks for the information. let me try this out this week

Any Sifu here can help me, how to set Alternate DNS on this maxis TP-Link Archer c5v router ah?

This is how I do it, not sure about IPv6, anyway I disable IPv6 for better stability

Thanks bro, will try this matter. Will disable ipv6 too :-)

how to disable ipv6?

so from network - WAN settings - eInternet, on right-hand side got an Edit button. Press that and untick Enable IPv6

just like supervai said.

also I disable IPv6 DHCP LAN,
as I notice sometime my device not getting an IP address assigned(hang moment while connect to wifi), after I disable IPv6 DHCP LAN then never face the same issue.

Is under the same menu as above >> Network >> IPv6 LAN Settings

My wireless network HP printer was not detected by my pc, tablet and phones even though the printer is connected to the same network.Do you reckon ipv6 is the cause ? printer was working fine with the previous Technicolor router.

Forget about the crappy Maxshit tplink c5v router, i have the same issues, thing i have done to use the alternative router,
In view of the error, it is the firmware bugs

This post has been edited by waisang: Jan 31 2019, 09:08 AM

Few things you can try:
- Make sure Client Isolation is NOT enabled under "wireless 2.4/5 >>Wireless Advanced"

- Check if the printer is really connect under client list then Assigned a static IP to your printer

- Make sure the Printer is connected to 2.4Ghz as host network
- PC is connected to the same wireless frequency as the printer

I had the same issue as yours earlier on with my repeater and one of the HTPC but tv box doesn't have that issue (Repeater, HTPC and TV box connected 5Ghz while the rest of all other PC/phone is on 2.4)

but later discover I'm able to ping each other once I connect them to the same AP/frequency.

If all above doesn't work for you, i think you are out of luck with the provided router.

Anyone facing issue with maxis ftth?

Not able to connect, authentification fail

Call cs, mentioned nationwide issue

Using my mobile phone 4g now

No issue here. Klang area.

Thanks for update

I believe the issue is when you try to login

If you already login and using internet, then no issue

I just finish my spring cleaning and turn off my internet

When I turn on again, authentification fail

So make sure you don't turn off

Or if you dare, try turn off and on again, see if you encounter the same problem

No connection here in Ampang

Authentification fail?

All lights up except internet light?

Even the phone can be used, right?

Yup..same