Outline ·
[ Standard ] ·
Linear+
PROTON SAGA BLM, FL, FLX CLUB V17, Saga FLX SE 1.6 -> PRESSURE YOUR PEERS
|
MR_alien
|
Nov 30 2011, 09:22 PM
|
|
lol...3 sec is like not safe to drive already cross roundabout will surely crash its 0.5 sec only but the new part CVT oil pump and clutch adaption should solve that prob already
|
|
|
|
|
|
tanpanama
|
Nov 30 2011, 09:29 PM
|
Getting Started

|
QUOTE(MR_alien @ Nov 30 2011, 09:22 PM) lol...3 sec is like not safe to drive already cross roundabout will surely crash its 0.5 sec only but the new part CVT oil pump and clutch adaption should solve that prob already QUOTE(dares @ Nov 30 2011, 06:11 PM) Power - I'm not sure whether this is a characteristic of CVT or all the new Saga models, it seems that whenever I press the pedal there is a very noticable delay before the engine reacts (loud noise but no acceleration until a moment later). I remember experiencing the same thing when I test drive the 1.3 FL though I didn't really push it that time. The acceleration is satisfying and it can go uphill without breaking a sweat (On the same slope my Waja would huff and puff abit). The noise was quite loud I thought I was going very fast, but the speedo only show 120km/h  Acceleration delay and the noise would be my only complain as far as power is concerned.
|
|
|
|
|
|
poweredbydiscuz
|
Nov 30 2011, 10:14 PM
|
|
QUOTE(SiuYi @ Nov 30 2011, 07:24 PM) MR_alien yes. i found out after washing my ride, the cover will takung air a bit and flow into the small holes on the cover..i look up look down, no crack no leak at hood, the rubber is just nice..tak tau la.. my FL same as yours... ask SC guy during 1st service... he said 'itu normal'...
|
|
|
|
|
|
TSericmaxman
|
Nov 30 2011, 10:35 PM
|
|
QUOTE(tanpanama @ Nov 30 2011, 09:03 PM) i sehh.. i think "delay" already solve when proton launch FLX 1.3CVT. 3 second delay? same like 4AT? manual faster. 2.5 seconds hahahahaha
|
|
|
|
|
|
zeone
|
Nov 30 2011, 10:42 PM
|
|
QUOTE(poweredbydiscuz @ Nov 30 2011, 10:14 PM) my FL same as yours... ask SC guy during 1st service... he said 'itu normal'...  Normal? As in where did the water come from?  If my guess is correct, water probably seeped down fr between bonnet top edge and sealing rubber at edge of plastic cover of air vents below wipers. Still caused by poor seal by that rubber seal...correct?  Added on November 30, 2011, 10:44 pmps. Will chk nxt time me wash my FL. This post has been edited by zeone: Nov 30 2011, 10:44 PM
|
|
|
|
|
|
sg999
|
Nov 30 2011, 10:45 PM
|
|
QUOTE(zeone @ Nov 30 2011, 11:42 PM) Normal? As in where did the water come from?  If my guess is correct, water probably seeped down fr between bonnet top edge and sealing rubber at edge of plastic cover of air vents below wipers. Still caused by poor seal by that rubber seal...correct?  Added on November 30, 2011, 10:44 pmps. Will chk nxt time me wash my FL.  the rubber just partial covered so the water still can leak in during heavy rain
|
|
|
|
|
|
ming86
|
Nov 30 2011, 11:36 PM
|
|
any FLX 1.6 SE review from current FLX 1.3 CVT user?
|
|
|
|
|
|
TSericmaxman
|
Nov 30 2011, 11:40 PM
|
|
V12k somewhat quiet, lately.
|
|
|
|
|
|
xandras
|
Nov 30 2011, 11:54 PM
|
Getting Started

|
QUOTE(xandras @ Nov 30 2011, 11:51 PM) Up for test drive...  Anyone?  » Click to show Spoiler - click again to hide... «
|
|
|
|
|
|
BudakSimenXD
|
Dec 1 2011, 12:00 AM
|
New Member
|
QUOTE(xandras @ Dec 1 2011, 12:54 AM) Damn..y did proton bother to put a fake website decals on the windshield..sighh
|
|
|
|
|
|
xandras
|
Dec 1 2011, 12:15 AM
|
Getting Started

|
QUOTE(BudakSimenXD @ Dec 1 2011, 12:00 AM) Damn..y did proton bother to put a fake website decals on the windshield..sighh How is it fake? I can access it fine
|
|
|
|
|
|
BudakSimenXD
|
Dec 1 2011, 12:22 AM
|
New Member
|
QUOTE(xandras @ Dec 1 2011, 01:15 AM) How is it fake? I can access it fine  Sorry my bad
|
|
|
|
|
|
stanleypua
|
Dec 1 2011, 12:30 AM
|
New Member
|
Yor change ad recall item for flx, feel not much different now engine got krat krat NOISE !!!! and passenger side , fender got metal noise , wraghhhh!! Shuai !!!! Next week go back again d** Kaw kaw !!!! Really tak boleh tahan la service sucks !!
|
|
|
|
|
|
V12Kompressor
|
Dec 1 2011, 12:35 AM
|
|
QUOTE(ericmaxman @ Nov 30 2011, 11:40 PM) V12k somewhat quiet, lately.  I baru balik lah Today ada new product launch and a few appointments have to be scheduled tightly. Korek tahi hidung also no time. » Click to show Spoiler - click again to hide... «
|
|
|
|
|
|
SiuYi
|
Dec 1 2011, 12:53 AM
|
|
poweredbydiscuz itu tidak normal..i seriously needa find out from which part the water goes in...
|
|
|
|
|
|
herojack41
|
Dec 1 2011, 01:14 AM
|
|
i tot most auto car also got abit delay if u floor down the pedal ?
|
|
|
|
|
|
MR_alien
|
Dec 1 2011, 01:30 AM
|
|
QUOTE(SiuYi @ Dec 1 2011, 12:53 AM) poweredbydiscuz itu tidak normal..i seriously needa find out from which part the water goes in... abit of water or alot of water? if little water thn probably normal i can come in from the part below the windscreen where the water falls there it can also come from the front gap of the engine hood
|
|
|
|
|
|
AMenzZ
|
Dec 1 2011, 01:32 AM
|
|
QUOTE(herojack41 @ Dec 1 2011, 01:14 AM) i tot most auto car also got abit delay if u floor down the pedal ? IAFM campro do have abit delay. but if i compare my FLX cvt with my frens FL AT & BLM AT, it did improve abit. yet still got slight delay... Last weekend drove my fren FL 4AT uphill to Cameron, i can feel the car like torque-less, need rev to 4k rpm then only feel some acceleration...haha... havent try my flx cvt yet...
|
|
|
|
|
|
dares
|
Dec 1 2011, 01:40 AM
|
|
QUOTE(herojack41 @ Dec 1 2011, 01:14 AM) i tot most auto car also got abit delay if u floor down the pedal ? Not the ones I've driven. Even if there is any delay it would only be during high speed acceleration, and not as noticable. The FLX I tested today have this delay, which was very noticable, during all speed range, even from standstill. This post has been edited by dares: Dec 1 2011, 01:41 AM
|
|
|
|
|
|
AMenzZ
|
Dec 1 2011, 01:42 AM
|
|
QUOTE(dares @ Nov 30 2011, 08:19 PM) Are the SAT button still thr? This post has been edited by AMenzZ: Dec 1 2011, 01:43 AM
|
|
|
|
|