Wahh..nice speed u got there. :Envy envy:

goldfries, burn ur proc to get lower vcore

ehh. 24/7 running F@H also not burn enough ah?

CPUburn here i come, but later on la. now using stock heatsink. wait till my other heatsink come in.

F@H does not stress your cpu as much as prime or cpu burn-in.

yea...temp difference when folding and priming is bout 3-5 degrees...hehe...hope that gifs you a comparison..

bawww......... prime will crash after a few hours. i suspect heat issue.

not heat issue...its just that your ram got errors...processor is working fine.. try do a memtest...

This post has been edited by sidewinderz: Jan 24 2006, 04:22 PM

erm. i suspect heat issue 1st, cos using stock cooler and raise voltage.

RAM running at 228, i've not known it to be unstable on that speed but i'll check it out.

hmm...cause your processor can support till max temp of 69 degrees before "meltdown" so i think its pretty fine..

erm. last i saw it peaked at around 65 - 67 so i'm not surprised if torture test go gila when i was sleeping.

my XP1700+ OC also like that leh. on SLK900U. some times fan put too low, can't prime properly. put at appropriate speed - prime 24/7 no problem.

so that's why i suspect is heat 1st lor.

This post has been edited by goldfries: Jan 24 2006, 04:57 PM

hehe....might be heat as well...wonder wat is the idle temp to run the processor at..mine is bout 55 when prime...but 50 when folding...

ok just finished MEMtest (for Windows) no problem.

100%++ coverage, 0 errors.

how many loops? i normally do 500 loops of test 5....cause errors normally appears at loop 70+

how to knw MEMtest (for Windows) test 5 ? at which coverage is test 5 dos MemTest ?

erm. which version is this? i'm using version 3.3 for Windows.

is yours the version that have to boot from diskette? (ok i admit, i knew about memtest but for so many years i'm just too lazy to try it out........sue me.....)

accually how u all burn in ? let's say my proc stable at 1.5v .... i burn in use higher vcore ? 1.550v ? or lesser ?

mine is the dos version...that 1 is better for detecting errors....

@StarNet
well, you just set wat speed you wanna run it, set the min amount of vcore that allows you to do minor apps (like surfing and chatting) then prime it.....

yeah. i lz go DOS mode la. my system don't have FDD also maybe i try boot from USB. but again, i lz to go DOS mode (reset comp) so there.

i still don't get the logic for this

say i set the speed i want to run and min amount vcore that allows me to do minor apps. usually at this setting, my prime will have ERROR right at the start.

or did you actually mean prime at minimum stable vcore?

it wil got error at start rite
but continue to stress it till no error, but not every time success
oso saw som ppl burn proc at high volt
lol dun dare do tat

thts me, cyclone87 teach 1

running my cousin rig 1.44v at 345htt at 1st, burn with 1.7v at stock speed for 8 hours, result in 1.4v at 345htt