Welcome Guest ( Log In | Register )

Bump Topic Topic Closed RSS Feed
131 Pages « < 30 31 32 33 34 > » Bottom

Outline · [ Standard ] · Linear+

 ◙The New PROTON PERSONA◙ V5, Proud CAMPRO always... ^^

views
     
loong2020
post Mar 1 2009, 11:04 PM

Senior Star
*****
Senior Member
771 posts

Joined: Aug 2008
From: Earth


coz tuned by cheeann mah... brows.gif brows.gif ....oklar..if got time will come over do my alignment... rolleyes.gif
krk24
post Mar 1 2009, 11:33 PM

Getting Started
**
Junior Member
277 posts

Joined: Dec 2008
From: Puchong


Yahoooooooooooooooo!

Finally i got my very 1st CAR; Persona (HL)

So far I'm satisfied with the car except 1 thing; while taking corner, there is some noise on the stering. Need to check with proton!
cheeann
post Mar 2 2009, 12:21 AM

I love my suggie~
*******
Senior Member
9,799 posts

Joined: Feb 2007



QUOTE(loong2020 @ Mar 2 2009, 12:04 AM)
coz tuned by cheeann mah... brows.gif  brows.gif ....oklar..if got time will come over do my alignment... rolleyes.gif
*
dun push over d limit lo~
nanti masuk longkng not my pasal jor~ tongue.gif
farscope
post Mar 2 2009, 10:43 PM

Look at all my stars!!
*******
Senior Member
3,427 posts

Joined: Apr 2007
From: Gangster Paradise


attached the rust occurring on my car body.. cheap paint mad.gif

very very small dot anyway.. bout 1mm in diameter.. took using phone.. so not so DETAIL..


Attached thumbnail(s)
Attached Image
loong2020
post Mar 2 2009, 10:56 PM

Senior Star
*****
Senior Member
771 posts

Joined: Aug 2008
From: Earth


mine chip off....around 5/6dots.... mad.gif ....this time cut cost on paint....the thin coating is super thin..last time i put a bucket of water also minor scratches.. yawn.gif ...and then the windscreen also, seems that easily get chip off also if stones flying from lorries..but not on other car even old wira/waja dont have such problem vmad.gif ...last time interior & power window... rclxms.gif ..i think few years time, the car sure have to respray again... rclxub.gif

This post has been edited by loong2020: Mar 2 2009, 11:00 PM
onlyforthecars
post Mar 3 2009, 06:50 PM

Getting Started
**
Junior Member
244 posts

Joined: Jan 2003
From: pj
QUOTE(loong2020 @ Mar 2 2009, 10:56 PM)
mine chip off....around 5/6dots.... mad.gif ....this time cut cost on paint....the thin coating is super thin..last time i put a bucket of water also minor scratches.. yawn.gif ...and then the windscreen also, seems that easily get chip off also if stones flying from lorries..but not on other car even old wira/waja dont have such problem vmad.gif  ...last time interior & power window... rclxms.gif ..i think few years time, the car sure have to respray again... rclxub.gif
*
Speaking of respray, how much does it cost for a decent job? with thicker clear coat and all...
loong2020
post Mar 3 2009, 07:34 PM

Senior Star
*****
Senior Member
771 posts

Joined: Aug 2008
From: Earth


the last time i ask for respraying the bonnet...cost 180....whole car maybe 1k++ hmm.gif
jack111
post Mar 3 2009, 09:32 PM

New Member
*
Junior Member
7 posts

Joined: Mar 2007


Anyone facing these problem.

1) Sound "Klok,Klok,klok..." When run on uneven road, the sound feel like coming from absober, feel like something loose....

2) difficult to engage to 2nd gear......

Any solution???

amadeo
post Mar 3 2009, 10:06 PM

Mafia
*******
Senior Member
3,503 posts

Joined: Jan 2003
From: ..Whenever i may roam...
QUOTE(jack111 @ Mar 3 2009, 09:32 PM)
Anyone facing these problem.

1) Sound "Klok,Klok,klok..." When run on uneven road, the sound feel like coming from absober, feel like something loose....
*
Bro, no.1 solution i quote from our forumer many pages back..

QUOTE(laytiong @ Feb 12 2009, 09:57 AM)
ask SC to remove front lower arm nuts and grease them. tighten all lower chassis bolts and nuts

i had a knocking sound from both front suspension and that did the trick. must tighten all including cross member and kingpin bolts.
*
And also i quote from motortrader forum inside persona thread.. a reply for the problem no.1 by zariel_faiz
QUOTE
The sound kreeek...kreek is because the stabilizer bar under the car is the rubber bush is getting keras because when they spray anti rust down there... terkena pada getah kat stabilizer bar...after they umpil with besi and spray with 4wd....then its okey no sound.

jack111
post Mar 3 2009, 10:40 PM

New Member
*
Junior Member
7 posts

Joined: Mar 2007


Thanks, Bro.

Which SC u sent to solve these problem? coz i try send to 2 different SC before but they cant solve the problem for me.
amadeo
post Mar 4 2009, 12:49 AM

Mafia
*******
Senior Member
3,503 posts

Joined: Jan 2003
From: ..Whenever i may roam...
just print this page and bring to them and ask them to do the things listed.. laugh.gif
onlyforthecars
post Mar 4 2009, 09:43 AM

Getting Started
**
Junior Member
244 posts

Joined: Jan 2003
From: pj
QUOTE(loong2020 @ Mar 3 2009, 07:34 PM)
the last time i ask for respraying the bonnet...cost 180....whole car maybe 1k++ hmm.gif
*
i see. 1k ++ for a good quality job or for the same quality found on stock personas?
cheeann
post Mar 4 2009, 09:46 AM

I love my suggie~
*******
Senior Member
9,799 posts

Joined: Feb 2007



i dun think so cuz newer batch of protons all using 2k paints edi so i dun think i'ts goin 2 b cheap unless u goin 2 spray cheap paints~
yjeen
post Mar 4 2009, 10:24 AM

Casual
***
Junior Member
319 posts

Joined: Jun 2007
QUOTE(jack111 @ Mar 3 2009, 09:32 PM)
Anyone facing these problem.

1) Sound "Klok,Klok,klok..." When run on uneven road, the sound feel like coming from absober, feel like something loose....

2) difficult to engage to 2nd gear......

Any solution???
*
My car has this issue as well...need to check it out..
loong2020
post Mar 4 2009, 07:08 PM

Senior Star
*****
Senior Member
771 posts

Joined: Aug 2008
From: Earth


QUOTE(! Love Money @ Feb 24 2009, 12:16 AM)
hi!

from wat i observe the way that the sound occurs is same as mine, only on that RPM range...
but mine at 1800RPM, other range no problem

or if u wan to confirm u can do this... get other people or friend
find a hole on top of front bumper and see where there got this bar steel or not
then tell ur friend to hold that bar steel hard then u got inside ur car and rev the engine
the sound should be gone...

hope this can help nod.gif
*
well.....today when and fixed this problem...and mine also has the rusty line same like urs....added soundproof mat that is thicker and the sound gone....(for right now)....so guys if u have any rough sound occur around 1100rpm-2000rpm when u accelerating/free rev ur car...get the impact bar fixed... smile.gif ....and on the way back, i didnt feel the 100km @ 2800rpm vibration.... hmm.gif
drgnkid
post Mar 4 2009, 10:50 PM

Getting Started
**
Junior Member
109 posts

Joined: Feb 2008
QUOTE(yjeen @ Mar 4 2009, 10:24 AM)
My car has this issue as well...need to check it out..
*
It seems like all Persona's come with this sound. Just read from another forum that apparently there is a solution for it finally but don't know if it is true. Perhaps you guys might wanna try. Here's the excerpt from the forum:

"I've complained about the metal clanking sound, and apparently they've found a possible solution for it. This sound is caused by the STEEL POWER STEERING HOSE knocking on other surface, thus the klank sound. They've come out with a POSSIBLE solution by replacing the steel hose with rubber hose, but they did not change mine because some owners have complained that the rubber hose will crack in matter of weeks, so they have temporarily pulled back this solution. Maybe in the future they will replace this with a better grade rubber or synthetic rubber that can withstand heat better.

You can visit Autoworld forum, where a person has it fixed and he says the problem is gone. I can't confirm this as I haven't tried it myself.

http://forum.autoworld.com.my/index.php?sh...dpost&p=1371910

If you get any information on your next visit to SC, please share fast as my 2-yr warranty is about to expire! smile.gif"

I will probably bring my car to the SC this weekend to check it out.
loong2020
post Mar 4 2009, 11:01 PM

Senior Star
*****
Senior Member
771 posts

Joined: Aug 2008
From: Earth


hmmm...maybe u can try request for coating the steel hose with some rubber or soundproof mat (insulflex)....at least dont have metal to metal contact.... brows.gif check out the soundproof mat sold....so imo...coating that can solve the problem as got no metal contact with another object and thicker too...

http://forum.lowyat.net/topic/861949
cheeann
post Mar 5 2009, 12:21 AM

I love my suggie~
*******
Senior Member
9,799 posts

Joined: Feb 2007



QUOTE(loong2020 @ Mar 5 2009, 12:01 AM)
hmmm...maybe u can try request for coating the steel hose with some rubber or soundproof mat (insulflex)....at least dont have metal to metal contact.... brows.gif  check out the soundproof mat sold....so imo...coating that can solve the problem as got no metal contact with another object and thicker too...

http://forum.lowyat.net/topic/861949
*
kuat racun ini~ brows.gif
sandking
post Mar 5 2009, 01:08 AM

New Member
*
Junior Member
6 posts

Joined: Dec 2007
ya my car had this prob too..my car just aged almost 4month but mine is mostly while taking a left or right turn on uneven road dunno same prob like u guys onot sweat.gif sweat.gif
ralf
post Mar 5 2009, 09:05 AM

WYSIWYG
*******
Senior Member
3,013 posts

Joined: Jan 2003
From: Penang

QUOTE(sandking @ Mar 5 2009, 01:08 AM)
ya my car had this prob too..my car just aged almost 4month but mine is mostly while taking a left or right turn on uneven road dunno same prob like u guys onot sweat.gif  sweat.gif
*
It is a free feature bundled together with the car from Proton wink.gif cool2.gif j/k

131 Pages « < 30 31 32 33 34 > » Top
Topic ClosedOptions
 

Change to:
| Lo-Fi Version
0.0297sec    0.29    6 queries    GZIP Disabled
Time is now: 8th December 2025 - 01:33 PM