for me it sounds expensive......how much it cost jazzy (agak-agak)?

Wow NICE CASING U HAVE THERE ! how much how much?

I'd say it will 'look' expensive It's just a 'flash chrome' plating, followed by fine metal polishing, buffing.

I have this spare PSU casing, if you're on a tight budget, it will suffice. However the PSU will be on a separate similar housing. Certainly would look nice, side by side..

This post has been edited by jazzy939: Aug 22 2008, 12:09 AM


Attached thumbnail(s)

jazzy bro when can private audition???

Which casing are you refering to? gabanyayaya's?

wrong people wrong question....

Dunno ler.. need to find a nice free time for this..
However, have to wait until ALL is done for this T-Amp!
I just found huge(in size) caps that I want to use at the power input section...
Will update soon. Need to use that tonite as little improvements can easily be detected at this hours..

remind me once got the time ok,,,,,,,,,,,,,,,

Roger wilco!

Dunno if these caps will make much difference...

This post has been edited by jazzy939: Aug 22 2008, 12:47 AM


Attached thumbnail(s)

wow those looks solid...whats the uf?

just back form yamchar with uncle ongbs

so sad he is not impress with my t-amp

There're 330uF each. Total would be close to 2000uF.. Have not use them yet..
Why 'uncle' ongbs not impressed with your T-Amp?

That must have come from some PSU. Its not suitable.
What you need is uF that reads 5 figures (or you parallel them altogether) with a few hundred VA transformer (bigger the better).

Yes I know.. its from my defunct UPS
10000uF at least, the more the better!

hahaha

yea bsl is correct
330 seems small...uncle ongbs put 8200uf power improve

for me im planing to get 6600 for each rail, total up 13200uf, low esr, panasonic fm series

haha personal prefference but the soundstage was good, i got no bass in my car, im runing 3 way crossover with front mid bandpass, still thinking wat to do with sub, but at the moment ill concentrate on cleaning up my car interrior 1st, all messed up

No wonderlah ongbs not impressed!

yes yes. I was aware with what ongbs has done..
I will look into this when I have the time.. definitely!

The 330uF caps WILL NOT be used..

but for temporary try out...why not

Probably it's not worth the effort!
My PSU should be able to cope with any transient current drain.. I usually set the pre-amp volume around 9 o'clock position.
Now I only need at 8 o'clock position! Now clocking at 15 hours... and still clocking..

you nvr know

2000uf still way better then 2x220uf

my senior just audit my car and he say vocal very clear, but highs and mids like distorted..hahaha my hp volume max outlah and he dont know how to listen to soundstage, wont appreciate the beauty of it, especially in a car where soundstage are very hard to be reproduce

220uF too small although these chips has high efficiency, i would recommend anything > 6000 uF or couple the caps, 2000uF+4000uF

Okay, okay. Point taken.. the higher the value of the caps, the better! Will be in the checklist! Thanks for the advice!