QUOTE(X@H!3R @ Feb 11 2017, 02:36 PM)
Hey bros need ur help on my problem my lc v2:
1. When full throttle after some time will jerk2 and when throttle abit no respond and sometimes the engine shut off. Already change spark plug and CDI from brt to standard still the same.
check plug. could be plug dead or fuel delivery problem.
another possible cause, the petrol cock in the fuel tank is dirty.
some service history of your bike is appreciated...
QUOTE(overruled23 @ Feb 12 2017, 08:42 PM)
i takut nanti tanya soalan simple tapi dah jawab.. tak larat nak cari dalam 18 version punya thread.. haha
nak tau service interval and recommended parts for change
page 1 got manual link, please try it. report again if link dead.
QUOTE(Uqail&Ufairah @ Feb 14 2017, 03:14 PM)
Assalamualaikum & Hi to All,
Currently im installing Kawasaki AR125 wheel on my Yamaha 135LC V1. We found out the alignment of the wheel close to right (if we facing on the bike from the front - off centre). After a few modification yet its still 3-5cm off centre as we grind the disc bracket extension.
So my question is:
1. How can i align to dead centre of the wheel or
2. I need to chance T-Shaft and fork. If yes what other bike suits on this AR125 wheel and fits 135LC bike.
Hope any of the forumers can help me sort this thing out. Every comments and help very much appreciated.
1. You need the width of the rim hub, measured at outer face of bearings from left to right.
2. Calculate the remaining width needed, for the extension installed, to get a good fit to the fork or rear swingarm.
3. For the brake disk, you need to compare if disc to rim center is same as LC standard. If it is not, you need to compensate the caliper.
Hope it makes sense. You might need new extension sets and restart working on the installation.
Remember, fit the rims first, then the brake caliper. Do these separately.