buzzing and sometimes, dead silence. It happens once a while.

so... even if I have another blue UI astro box laying around, I can't use it? Road to only 18 free channels then?

You can try swap the smart card over

Hmmm, will leave my result here when I'm able to find one.

Btw are you able to use your old Astro box to view these channels now?

148, 601, 140, 502, 602, 200, 149, 147

502 -> yes. Channel “name” showing BERNAMA but showing Tutor SPM.
149 -> not in my subscription. WHUT?!
147 -> comes n go

Numbers not mentioned are showing service not available.

The channel list seems outdated. You need to refresh the channel list.

On your Astro remote control, press MENU, select Satellite Signal.
And then press OK to Download. Wait about 1 minute, it'll refresh the channel list. And then try tune to these channels again:

148, 601, 140, 502, 602, 200, 149, 147

I tried doing that b4 going thru the channels. Got 0-weak (red) signal.

Oh, you need to go MENU>Installation setup>Manual Configuration.
And then press down button on remote 2x to go to "Base frequency", and then change from 10.982 GHz to 11.682 GHz first.

Note: Please make sure your LNB Powering option is turned On.
Save the settings, and then go back to MENU>Satellite Signal again.
See if the signal readings is now shown in green colour. If yes, press OK to download list of services (means refresh channel list).

And then go through the channels again.

This post has been edited by joshhd: Jun 28 2021, 02:03 PM

Manual config and it asks for pin. Not able to proceed

Oh sorry forgot to tell you.
Default PIN is 0000 or try 1234

Pin tried 0000.
All channels are viewable but still my audio has buzzing sound. Thanks for the frequency change tip.

Glad to hear that

So you're able to view these channels too? You don't see "Service currently not available" on these channels?
148, 601, 140, 502, 602, 200, 149, 147

As for the audio buzzing thing, try use other RCA cable to connect to your TV.

This post has been edited by joshhd: Jun 28 2021, 02:50 PM

Yeap. Able to view. Weirdly Tv1 & 2 is down.

Will try looking for another RCA cable. 😅

Hmm... I believe channel 122 also showing Service Currently Not Available, right?

Anyway, if you encounter any issues with your legacy Astro box, such as getting 0 signal reading at the Satellite Signal page and unable to update channels, feel free to post a question on this thread.

Another RCA cable tested, same result. Comes and goes. I actually start to wonder if it’s actually because of this action that causes it to have buzzing sound, spraying WD-40 on the contacts of the cables.

Thanks for the help tho! joshhd

*edit
Have not tried channel 122

This post has been edited by PoisonSoul: Jun 28 2021, 07:27 PM

that mean ur box is not supported, coz tv 1 ,tv2 & tvs is in hd

EPG for channel 146 TV OKEY is duplicate with DIDIK TV KPM(NTV7)ch 147, until now is not fix, already inbox Astro & wait

That's because Astro have been "reshuffling channels" from one transponder into the other, but it seems they "forgot" to update the EPG accordingly

Yes u r right.

latest update:
NJOI Sd free chennel, Astro AEC (346) subtitles is up, but limited to malay subtitles only, refer to picture below