QUOTE(yonghong @ Jul 11 2014, 10:00 AM)
Hi bros. the noisy sound cleared following the ways Kiefer bro teached. I got one very newbie question, is the predicted "km" shown at the screen there can be trusted?
mean if it is showing 109km left, but the indicator of the petrol is blinking already, is it still can drive around 109km?
n also i find that my FC quite low, only 9.5km /Litre only. bt tat is immediately pump petrol after blinking.(still showing 100km left".
Thanks for answering my question. highly appreciated.thanks.

Hi YongHong,mean if it is showing 109km left, but the indicator of the petrol is blinking already, is it still can drive around 109km?
n also i find that my FC quite low, only 9.5km /Litre only. bt tat is immediately pump petrol after blinking.(still showing 100km left".
Thanks for answering my question. highly appreciated.thanks.
Great that you 'kautim' the sound.
On the FC, it should show L/100km not KM/litre. It actually calculate the average usage, for me it is somewhat accurate.. not perfect though i think but it is a guide for me.
When it shows 109km, (if hiway, it will show 125km or more). It give you a estimated range before ran out of fuel. If it is below 50km range, it will show '-------' I tried below that, but dont dare as i dont want to push my car or walking to the petrol station. hehehe
now my FC is about 8.9 - 9.1L/100km when in LDP during peak hours. But best to pump petrol soonest possible when you have the chance. For me, I will have at least 50km to go when start blinking especially in hiway next stop.
On your case, after pump petrol and still showing 100km... then you try off and on again as bro SingK mentioned.
If still show like that, i remember there is a way to reset the Range by holding it down for seconds. Try look at the owners manual.
If still same.. service center is the way to go.
Jul 11 2014, 03:05 PM

Quote
0.0316sec
0.42
6 queries
GZIP Disabled