Thank you!

Dear all,

Just would like to know your opinion. I am planning to install air cons in the bedrooms and cassette aircon in the living room. What should I do first? Air con or plaster ceiling? Thanks in advance.

Install cassette Aircon blower steel hock 1st with those piping.
2nd step do plaster ceiling, the contactor would ask you given them of size opening.
3rd step all done and painted, then install Aircon blower.

That is what I guess, maybe I'm wrong

My condo unit is at highest floor and the living+dining area is about 280sf, i should go for 1 HP or 1.5 HP?

Next time you all can give the room size in meter much better to calculate.

14x20ft = 280 sq ft. (14 ft x 304.8 = MM)
Or in meter 4.2m x 6m that is consider bigger space

The only way go for 1.5 or 2.0hp for living room

Cheers

The size is 3.35m x 7.7m, please advice...

can use this calculator:

http://papamy.panasonic.com.my/support/Hor...ower_Simple.asp

Based on the result, 2HP should be just right for top floor, especially if u opt for Inverter model..

hey guys,

since we hardly to buy air con filter here , i plan to bring in 3M Filtere Air Con filter , 38cm * 180cm , high performance series... price about RM90 ... for my own use and extra to be sell over here ....

Anywhere i can get mitsubishi electric brand AC in klang valley area with reasonable price? ESH price is at high side...

Hi
I got aircond qoutation for daikin inveter type
1.5hp rm1480
2.0hp rm2380

Is it reasonable price? Without installation

where you quote this item?
Price seem reasonable on the low side.

I got supplier from penang. If confirm can nego little bit

Hello All Sifu, do you guys have any reputable aircond contractor to recommed here? planning to change my master bedroom dinasour age york aircond to inverter type.

Also to fixed my new mitsu starmex aircond indoor unit water dripping issue.

Best still if they do exhaust fan installation coz I need add a few of them.

By the way my location is Tropicana,PJ.

Thanks in advance.

This post has been edited by jenhuei: Mar 30 2014, 12:05 PM

Just installed Mitsubishi Mr Slim 1hp MS-GH10VC non-inverter. Cost me RM1100 with installation. So far so good

Looks like reputable brand's 1HP still need rm1000-1200 all in

where you quote this item?

I bought this Hitachi RAS-XE10CC from HLK SS2 in yesterday, with Installation cost around RM1350.

It comes with two years manufacture warranty + ten years compressor warranty.

u should be able to get non-inverter below 1k.... 800-900

In johor from mitisubishi ac dealer. Also got FOC foam pillow as gift.

anyone use their ac with separate unit air purifier?



This post has been edited by mnibar: Apr 1 2014, 05:18 PM

I installed 1hp Mitsubishi Mr. Slim on my small room 4m x 4m, even I turn to 16C with full fan speed, it hardly get very cold, it just feel little bit cold,don't know what happened, just installed on Jan 2014, same thing happened on my other 2 small rooms.

But in my master room I installed the 1.5hp inverter type Mr. Slim, I only turn to 26C, fan speed half, it is quite cold. this 1 I very satisfy.

but for the 1hp non inverter type seem not so good...