what happen to ur 170 bro...

haha thats rite, i got the last opty

anways, i tried 280 with my 2.9V but still not luck.[sry still noob at overclocking]

ph yeah i forgot to mention that im on stock HSF coz not enuf money to get my XP-120

did u try lower down ur memory divider and ur ldt multiplier????

i did not use a divider yet.
shucks do be honest i dun really noe how to use one

well mind to tell us ur rig's full spec ar???

remysix..
i got not very good weeks.. 0541.. but i havent try anything yet.. stil travelling.. only tomorrow will go back home.. if i can hit 2.5gig stable then i'll be happy but if not then i'm thinkin to let it go..
but still has no mobo n hd yet..

darkshyte..
what are your stepping??.. n what mobo r u using??.. if you're run on stock coling then 2.5 is very good oledi.. try to fit thermalright xp-120 n see if there got any diff.. try to raise voltage also...

yeah sure[sry for not posting earlier ]

Opteron 170
DFI expert
CORSAIR XMS4404v1.1 4400C25PT PC4400
Ati 1800Xt
Creative Elite Pro
enermax 535W

This post has been edited by DaRkSyThE: Dec 14 2005, 10:12 PM

that's an owesome rig man... WOW!!...

yeah cost me a bomb just missing the my XP 120

Entering the 3GHz Club.
Vcore: 1.45v + 110%
Vdimm: 3.20v



Measured with DMM, actual Vcore hover around 1.60v. Guys, don't pump Vcore too high on DFI NF4 'cause CPU-Z never showed actual reading

dun think is cpu-z prob...more of the voltage sensor on the mobo not accurate....what to do....need to cut cost and maximise profit

no such thing as voltage sensor. temp sensor yes.... voltage sensor no.

the voltage reading can be easily obtained thru the circuit itself, without any sensor needed.

hey guys,
i tried a few settings yesterday and the only ones that worked for me was

Vcore: 1.25v + 109%
Vdimm: 2.9v
divider 180[not really sure bout this one]
@2.6GHz

when i ran super pi at 32m no prob.
only when i started prime it stoped in seconds.
now im running at my previous settings[2.5GHz], and after half an hour my prime stops.

any suggestions ?

This post has been edited by DaRkSyThE: Dec 15 2005, 01:20 PM

there's difference between prime stabile n super pi stabile..... n the vcore setting is quite low for 2.6.. try to raise it slightly.. and what cooling r u using?..

and i need min 333 htt to get to enter the club
this opty is damn hot, no matter what vcore i used or how best i reseat my xp120, still at load, the temp naik sampai 52-53c...cannot du sub-50 --> limiting my oc

stock cooling
i noe that there is a diff between prime and super pi
what im saying is that its pi stable but not prime stable...

I can even run my 146 with 1.3v + 103.3% @ 2.8ghz stable, so I think 1.25v +109% isn't a problem for 2.6 to be stable.

i did 1.425v + 109% @ 2.6ghz yesterday,
but when i ran prime, it stopped like after 2 min...
shud i increase the vcore more?

remyx, you can try 704-2BTA and see if there's any difference in temperature. By the way can you boot into Windows at 3GHz? And what Vcore does it need to do that....