ermm.. actually can some1 explain to me wat is burn in.. for wat? does burn in can increease d proc speed?

burn-in is actually one method in binning process

for lucky people.... burn-in can increase their max clockspeed

Haha..it sometime like 50:50 playing with ur proc...my venice give me no improvement..only my S64 and tbred got improvement. Usually can run around 75-100mhz higher on default vcore after the process.

everyone oso like to search for luck

wow.. imprssive.. wow... had to burn in for 2 days any fatal errror will causes to d proc? never try it b4... so wats d correct method? or jus giv me any link will do..ill read it myself...

Actually this burn in method was long practise during Tbred time. Now hardly find thread bout it. I read from guru3d and it really work to me tbred..so then it sometime i will do everytime i get a new chip to play.

would burn in work by doing F@H with default vcore / speed?

F@H not really stressing the cpu AFAIK.

if i were to run sis, how long should i run it? cause now i set 2.68Ghz@1.7v doing folding work...seems stable...cant seem to get it to 2.7ghz cause my rams limiting me..223Mhz is the besti can go for my rams..

I think you actually can go higher with current voltage, it's just the ram limiting you all this while

time to up RAM voltage, or if not - increase the divider.

i know i can go higher...but my rams...argh!! did memtest at 336HTT and errors start coming out...after all, this is as far as wtm went as well 335HTT...20mhz wont make a lot of difference right??

been reading up bout burning in in Xtremesystems..the method you specify is actually quite similar to it.and they say it works...

hmm..i'm already on 133mhz devider...lower will be 100mhz...which will significantly slow down everything...i'll try to tweak around with my ram settings...current Vdimm is 2.8v

does burnin in is danger?coz if burn in need to feed d proc wit high voltage=more heat.. wat if d heat sensor got bugs? get wat i mean..act=70c, showed=60c

dangerous if you know nothing about what the hell it means and also what you are doing...

Burn in require fine attention in making sure components do not fail due to higher voltages being applied or heat increase rapidly and above components working temperature....

i burn it yesterday using 1.7v running stock speed for s2500+ for 10hours, now priming 3 hours with 1.42v stable so far which is previously need 1.44v for 345htt

will burn again later hehe

erk???the other way round technique....owh at least it helps(works)....congrats...

Actually...if there is effect..mean it already success..so no use for futher burning as there wont be improvement anymre from wat i experience.

i jus try burn in jus now.. issit normal that d whoe system like wanna hang? i cant do anything at all while burning...

This post has been edited by low yat 82: Jan 4 2006, 03:34 PM

if hang...then ur PC has freezes...if lagging than its normal....

oic.. now reduce d cpu fan coz dun wan to up d vcore too much coz using not good psu