you need to adjust your valve clearance.
knocking is bad. will cause damage to engine in long run.

Will ask my mech to adjust it then..

Do you guys know where to replace the rubber lining on the car roof top? the two long black rubber on the left and right...one of my rubber flew away and i just realise after only i reach home...

paint shop ppl can help you.

paint shop ppl can do it??? amazing, i don't know about that. Thanks!

Anyone interested to buy my baby??

http://forum.lowyat.net/topic/1869950

just leave it empty, i change one side rm 90 and then kerja pasang havent kira some more, btw proce should be rm80-100, more is considered chop u dy

Try ask spare part shop or accessories shop. Also, you may want to check and ask for the clips also, in case any broken or flew off.

Also, when you are fixing, becareful when installing it, as it extends from the side of bottom-front-windscreen to bottom-rear-windscreen (for wira sedan). There is one time I put back and whack the back portion a bit too hard. Next morning, my rear-windscreen fully cracked Lucky got buy windscreen-coverage

Last time one of the member here after buy the lining and bring back hometown then only realise it is different length than his car. So yeah better measure it 1st if plan to DIY or take to other place to install.

anyone know how much cost for changing engine mounting?and how to know that our car need to change mounting...

Which model? if 1.5 its around RM300

yah thas 1.5..dem...so costly r??got any effect if not change the mounting?

Plus workmanship ma.....

Effect is you will feel vibrations in your car while idling

Vibrate more..just like my Wira now

Just changed one unit (on top, next to timing belt) cost me RM50 (whole unit, metal + rubber). Not sure kena potong or not by my regular mechanic.

This is due to engine oil leaking, from 2x oil seal. Have to take out timing belt, etc. Since doing that, also change my 60k km timing belt (not due for another 20k km). Mechanic says and shows the belt is covered in oil, and recommend to change it, since it may crack easily or putus while driving (degraded). Sin-ka me ?

1x timing belt (RM80)
1x another belt (forgot) (RM10)
2x oil seal
+ labour for all
= RM200

Expensive or not ?

consider cheap~

1 bijik RM30-50, got 4 mounting. Workmanship shouldn't be expensive coz Wira mounting position is quite easy to take out. If you see your mounting rubber all cracked out or torn then you need to change it.

cute_boboi, Normally mechanic will ask to change the belt if it covered in oil. Not sure sikalan or not, but better change lar coz if the belt snap or come off from the cams your engine will suffer serious damage.

Ok, at least my mechanic is still trustable now

I only found out the mounting is spoil, when taking out the timing belt cover. Need to unscrew the engine mount, and the whole rubber ball inside, fall off into 2 big pieces from the metal.

Mine is Hero 1.5M GLi

Still haven't fix my temperature gauge fluctuating yet (posted in earlier pages here), and mechanic says my rear-drum-brake have issue that need to check in next service Coz I ask to tighten the hand-brake.

so anyone noe best and good workmanship for body repair and touch up?i mean value for our money.not too high and not to low price.normally how much cost for repairing our car roof ?its getting rusted and will blow anytime..huhu..btw area selangor kl.

so expensive..but..if i leave it empty it looks like botak =.=

wah...i thought they already noe the length..

i think i won't be like him gua i prefer to ask the acc shop staff to install for me