test it out and find out Best way to learn. Go on Auto SPD and 1:1 ratio for your FSB:Dram and go all the way.

i use Real temp to read my core temp...i test the sensor and i get sensor movements for core 0 = 5 and core 1= 8....wat does it mean?

Anyone got advice on vcore settings for highest OC with a Q6600 running on a P35-DS3? on either 7x/8x/9x multipliers?

Currently highest OC is 3.5GHz at 389x9 1.55v stable. Cooled with a S1283. temps were really high... reaching 71'c-73'c...

but now, for daily use it's 3.2GHz at 400x8 1.4v stable. temps are 56-58'c load.

Help??

lower down ur vcore..

already tried vcore from 1.35v-1.55v. only one that was stable with is 1.55. so, how leh?

tried 1.40v-1.55v with 438x8.. also can't boot.. any ideas why? currently running 3.5GHz but now temps go down to 66~69'c. better than before..

which vcore should i take note of? in bios or in CPU-Z?

This post has been edited by Braynumb: Aug 10 2008, 11:02 PM

that means u will have to use run it at speeds lower than 3.5ghz lo since so hot already...

other than that, get a better cooler or go water cooling...

see your ram also maybe your ram is your limitation suggested go for 1066mhz ram if u wanna do stable oc...better still get a performance ram

@enson
ooo... no money leh... hehehe... maybe just stick to my 3.2GHz ler... guessing it's the rams also... juz TVR only le... maybe next time

@tkh_1001
tried WC, temps were worse.. now just sticking to AC...

Could someone give me some guide on how to overclock a intel E8400? information needed too thx

WC are cooler if you willing to spend over RM1k+ for the entire set,
or else, stick with AC still the best choice...

i dono give this link how many times liao

http://forum.lowyat.net/index.php?act=ST&f...0#entry15451675

going to do some mod on my waterblock 1st... then maybe later will test it again and see where It gets me... hopefully it'll do me some good and might lower my temps to under 65'c at 3.5GHz...

i love air cooling lolz

Mind to share spec of your loop?

my loop ah... rojak loop leh... custom waterblock from UglyVamp, Tt single fan radiator and Nirox 2800 pump... hehehe...

E0 stepping is so.....



This post has been edited by xchoit: Aug 19 2008, 02:10 AM

No wonder why temp so bad The rad is only single fan

wah lao...

that one is urs ka?

For my quad, im using 400 x9 settings on my P35 DS3 board.

3.6ghz at 400 x9 1.4875v bios set. load temps with sp2004 x4 would reach 70c. folding load max 58c.

btw im using watercooling to cool this quad beast

any news on the 8400 E0 in LYP?