Hey guys,i want to sell-off my Gen 2 Hi-Line's leather seat cover which in beige color.Fullset including front and rear seat.Anyone with M or B line wanna make their seat leather,can pm me.Thx

now using that pad.. front & rear.. brake grip good.. pedal feel softer.. so far no squeaks in the morning.. much better than oem lo.. using for 2-3 weeks edi.. daily driver..

---

Added on February 12, 2010, 3:00 pmbro, what type did u change to? how much and where to get?

This post has been edited by wandzul: Feb 12 2010, 03:00 PM

anyone use this spark plug before?

i am experiencing overburn on 4nos spark plug which cause the car lost power afer 40000km. I change back to my old denso iridium IT20 which did not suffer overburn.

you can have 16 ground pins on the plug and still only 1 spark generated, might as well use a plug specifically designed to make the best of that one spark.

Wan to wrap with fabric.Dun wan leather lo

price wise, is it cheaper or more expensive than OEM Proton?
havent change my brake pad yet, now considering.

price wise is almost the same with mintye (OEM) pads if u buy straight from w/shops..

---

Added on February 13, 2010, 10:14 pmthat means... online ceramic pad = offline mintye pad..

This post has been edited by wandzul: Feb 13 2010, 10:14 PM

wohkey,thank you for your explication

gonna need it. front and rear

bump!!

fuhhhhhhh nicely overburn...not enuff fuel supply i guess...FPR>

change oledi?

i use AFI brake pad Olymas rated 400degree...cheap n ok la kot haha



or maybe pro-ride

erm im using fbk brake pad, cost 45 bucks for me..

iz fbk a good brake pad?

as long as it can stop , means good

i use shimano brakepad

anyway a good brake pad actually depends on ur driving behavior as well...

if u drive at 100km/h n only brakes when u are about 50 meters from the front car bumper then u need a good pad that can withstand high enough heat from ur brake rotor(err it is called rotor right? haha i hentam oni)...

if the heat range not high enough, it wont grip and u'll end up kissing the front car bumper lor

erm b4 this i used mintye aka proton brake pads, n it su x imo..

between full flat n got longkang one, which one better? i noticed full flat brake pads tends to dust more..

turning radius is controlled by the ratio of the steering rack. if u notice waja, gen2 and persona has 2.8 turns lock to lock whereas other cars may go above 3 turns. more turns allow a smaller radius but the steering will not feel as direct in hi speed...

the one with a cut/gap/longkang are better, they allow better cooling and also the heated air trapped between the pad and disc to escape instead of forming a 'cushion' between the pad and disc.

ok thnx..

so i guess its a wise decision for me to use this fbk brake pads...

the mintye @ proton is full flat brake pads...

i'm using Bendix brake pad. Less dirt ...

Another story to share..
my steering got "squeaking" sound everytime the stereng rotated(either light or hard rotation).
Last time when bring to SC to check, they said nothing was wrong, and they put oil to reduced the sound. (yet, the issue still occur )
So i bring back just a few days back to recheck, and they asked me to change the stereng rack for RM 1.5 K
Dont have budget for now..haih ~

get 2nd opinion from outside under cherry tree bengkel