I prefer 3.3Ghz but if can pass 3dmark06 cpu test on 3.2ghz then its already okay...right now ram speed is at 200mhz...testing 3dmark...

update: still failed 3dmark06 cpu test...

This post has been edited by Shah_15: Oct 22 2008, 05:20 PM

lol don't put 200 la.. put 667.. increase vcore a little bit..

okay...increase vcore to what?

vcore for each proc wont be the same bro
u gotta test it urself and find the rite vcore
which can achieve the speed u desire

e.g : mine could achieve 3.3ghz wit 1.4v but urs might need 1.5...got it?
so the best solution is try running the benchmark..and later
if not stable yet, bump the vcore a bit and test it again
until it is stable

---

Added on October 22, 2008, 5:32 pmvcore for each proc wont be the same bro
u gotta test it urself and find the rite vcore
which can achieve the speed u desire

e.g : mine could achieve 3.3ghz wit 1.4v but urs might need 1.5...got it?
so the best solution is try running the benchmark..and later
if not stable yet, bump the vcore a bit and test it again
until it is stable

This post has been edited by mruzian: Oct 22 2008, 05:32 PM

yes look also your temp etc.. must see also other limitation.. must do by yourself..

still failed to pass 3dmark test at 1.56v vcore...

What's ur HTT speed? Maybe ur HT speed is too high?

My HTT speed is 1004mhz.

ya better put all the info - easier to counter..

What you all need? i will post the info i got..

1.5++ vcore quite high la bro. how the temps?
edit. din see already 3.15.

pls show ss of cpuz. cpu tab, memory tab, temps...

2gbx1 ocz + 2gbx1 kvr isit?

This post has been edited by ameque: Oct 22 2008, 05:49 PM

Temps so far okay...3.0ghz no problem at all...only problem at 3.2...

never trust d software readin as brisbies come w/ spoilt dts...

here it is:



no...only 1gbx1 ocz + 1gbx1 kvr...

i never used 3dmark before so dunno if ram or cpu problem. try stress using orthos so easy can detect cpu or ram problem.

u tried lowering the HT link below 1000? x4(800) or x3(600)

edit. again i din see ur siggy.

got option for ht link bandwitdh, ht link multi (i think). change bandwitdh to 16, the multi to 800 (or x4) or 600 (or x3), whichever available.

This post has been edited by ameque: Oct 22 2008, 06:15 PM

how to lower HT link? i still don't know how.....i'm using Evercool K8 Cooler..

i think ht link is fine.. just pump more vcore.. brisby need higher vcore for 3.2ghz.. try 1.45v.

I already put 1.5v in my bios but the cpu-z still showing it as 1.340v.

Did u turn off ur CnQ??

Dont dual ur ram run at dual mode channel if both of the ram r no same chipset , no same side and no same speed

@Shah_15
i think u better run ur ram with single channel