i wonder how does it feel when driving with clutch.. since b4 d G25, every wheel has no clutch..

well u can either
a) driva a manual car
b) get a G25 and ride it full blast to ur heart desire

oh well. driving a manual car rite now.. dun hav d luxury 2 hav a G25 2 blast.. stay with momo 1st

hahah never mind soon can follow us.........coz im doing both driving sports car on game and real life hahahha........

muahaha..celica FTW~~!!


cabutz *

walao, both in game n real life ah? sifu oh!

Hi guys, I'm thinking of getting one MOMO here but the problem is I think my table is too thick for the clamping. Ryugan, I remembered you showed me a thread where everyone show their cockpit setup, where was it ah? I forgot where already...

this is the site,
http://forum.rscnet.org/forumdisplay.php?f=186

Not sure is the one ryugan recommend or not.

Hmmm, not the one I wanted but the link looks interesting though. I'm going to have a look on it. Thanks a lot!

This post has been edited by BlueWind: Apr 28 2008, 04:52 PM

u can use this thread but have to register first

http://forum.malaysiansimracers.com/viewtopic.php?t=447

pm me when u have reg so that i can activate ur acc

Thanks man

But the reason why I want to look for these threads because my table is a bit too thick for the clamping. I'm looking for ways to fit it as I don't have extra table or so.. Anyone could give me suggestions?

post picture of your table,
first picture without momo - front and side view.
second with momo - front and side view.

I'm planning to get one soon, I haven't got it yet. So I've been thinking what solutions I can get before I purchase it, otherwise I don't think I'll get one if I failed to find a solution. Bear in mind that the thickness I measured is 13cm.

Here's the picture of my desk :

Whoa..thats a bit too thick...im using a typical office desk and my momo couldnt fit at first but i loosen the clamps screws at the sides abit and managed to squeeze it in. I'll do a measurement later on and let you know.

Btw, thats a drawer is it? Would u be able to take it out? If u can then it'll be perfect.

---

Added on April 28, 2008, 5:37 pmO ok so urs is 13cm...i'll let u know mine...but i think mine is thinner.

This post has been edited by maranello55: Apr 28 2008, 05:37 PM

Well yeah, it's a drawer, I thought of taking it as well but there's a problem underneath the drawer there's one plank that supports the drawer.. I've been thinking of other ways to fit the MOMO with other table or anything but for now I couldn't think of any cheap ways to have it..

Just my opinions. Using photoshop, so not so nice, hope you understand what I mean.
The extension part is to screw the momo

I'll think about that

That what I did for my computer table. Cos if buy new table, although can fit momo nicely, but have to move all stuffs to new table, very troublesome, so just DIY the table.

Can I have a look?

Sorry bluewind i think i overestimate my desk thickness. My table edge is not as thick. Can u show us a pic of ur drawer support?

---

Added on April 29, 2008, 11:39 amI have an alternative for u but its out of budget.

http://www.simracingstation.com/GB/WHEEL_SUPP_DESK.html Actually u can get a G25 with that ridiculously priced thing tho....

This post has been edited by maranello55: Apr 29 2008, 11:40 AM