Most key maker will be able to do that. Don't know how much it will cost

Yeah..a key maker quoted me 50 for one , but I guess he refers to 2 buttons as I forgot to tell him mine is 4...

Thanks guys..

Hey guys. What is the diffrence between 2 button remote and those more than 2.?
Does it mean that those remote that has more button can do 1 side gate open whereas the 2 button remote cannot ah?

if you just buy hardware from lelong, how do u program the remote that you bought? i know there r dip switch inside the remote, but i remember that we need to tune the frequency for the remote as well using the special device?

May I know what's the price for auto gate motor and cabeling for the brand Celmer? My autogate got problem just after installing for 2 weeks (alignment haywire and insensitive remote control) and I wonder if I was given an inferior brand. My neighbour installed their autogate for cheaper price and no problem at all with their autogate.

RM1800, just the motor and cabels.

The brand is Celmer. Yeah, install cable from switch inside my house to the gate pillar. Use back my old gate without doing the bearing.

My neighbour did for RM1700 and include bearing. I don't mind the fact that I pay more than my neighbours but I'm starting to wonder whether I'm paying the price for what I get? Or I was over quote?

So far, comparing theirs to mine, I noticed their gate open and close quite smoothly, remote can be sensed from far. Mine : open and close very slow and now left hand side became slower so currently looks very imbalance. When I press my remote to 'open' then try to press again to 'stop', the gate don't respond to stop immediately. Need to press one more time, only it will respond. 

Are you using the type of auto gate in which the motors are concealed underground? If I recall correctly, I have come across recently that it cost less than RM900 include installation; but exclude the amour cabling from the house to the gate pillar. As this system is underground, they are prone to water seepage due to hardening of the rubber seals. Thus damaging the motor. On top of that, there is the problem with hydraulic leakages. Following these reoccurring problems, many suppliers are reluctant to supply these system to avoid complains from house owners.
I was using this system in my previous house and was having problem in getting replacement parts.

How to say.. the simple 2 button type. One for opening one side only, another to open two side. Press back the same button to stop and to close back.

Not trying to compare price.. but very sakit hati when you see the door doesn't operated as good as you want. Just need to know.. am I paying the correct price for Celmer autogate? If yes, then I accept the fact and ask the ppl to come again and adjust.

Weikee,
Which one you recommended for autogate? What is the price range and reliability.

is my time to go for autogate after read some review from several website, found few comments but which are relatively low

http://www.planetmy.com/blog/auto-gate-problem-again/
Mentioning problem for OAE autogate and giving some good feedback regarding DCMoto brand.

Anyway, for those who are looking for product Brochure for autogate (ignore the price as in the website), just wish to have a look on the spec, you may go to the site below, quite informative
http://autogatemalaysia.blogspot.com/

before this think of submerged, after considering the seepage of water issue, then plan to go for the swing arm system (exposed one)

because I read from here the last section, the typical underground arm motor flooded due to seepage of water after several years.