if i sell my evic vt what should be the next mod that i could get ? budget less than RM300

Well it depends...

You want more watts? RX200 (or the RX200s for the awesome screen with a little bit extra).

You want more watts but don't want madu 3 batteries? Cuboid.

You think 70 watts is enough and wanna play with customizable everything (eScribe)? SMY DNA75 (single 18650 still trumps the current crop of 26650s unfortunately). Also the S-Body DNA75 if you don't mind an internal batt and want a smaller mod.

You think 70-80 watts is enough and you wanna adjust your vaping (and all other manner of techo-magica) though your phone? Smok Quantum.

Those are my recos for "around 300" from the top of my head.

Tenggiling_Besi No sifu here but this is what I think.

Considering your RX200 shares it's chip with my Pico, spaced dual SS316L coils of about 0.3 ohms and above should work fine (0.5 ohms and above coils are even better for TC, but for our JT chips above 0.3 is okay already).

As for wraps and ID, well that depends on the size of your deck and the optimum wicking size of the RTA (I don't know because I don't have a Griffin). To start with, try 26awg, 3mm ID coils coz that's what I have in my Pico + Cado and it's running TC like a champ.

Also, if it hits Temp Protect AS SOON as you fire while set at 400-450f, something is wrong. It should start at about 70-100f and steadily go up (and usually not even reaching 400f unless the wicks are dry, as least with mine set at 40w).

If it's not a hot enough for you, up the wattage as well as the temp (like I said, 40w doesn't really breach 400f normally, but I'm using TC as a limiter rather than a regulator).

Claps? Well, I don't run my ADV with fancy smancy wire so I can't really comment. My Velo + VTC does run twisted SS TC though but it has proven to be rather... finicky.... and likes to jump out of TC suka-suka hati when it wants to. Maybe I'll try Claps next.

This post has been edited by Eiraku: Jul 20 2016, 07:50 PM

Depends on you. Smok mods are good these days. There is R-Steam and H-Priv. X Cube Ultra is coming as well.

thanks bro...got all the information that i need...i'm gonna give an try and error later...thanks again

Guys,

Have u guys try exporting Local Juice to China?

I want to know how

Which courier u use

How many liter can sent in 1 shipment?

Btw,i dont know if u guys know this,our Local liquid is a hit in china now..

Which part of China? Any source?

Shandong

My source is my fren from china,he currently work here in malaysia...fren of him at china inform him this

This post has been edited by deanunited07: Jul 21 2016, 12:44 PM

nupage after lunch ..

lunch finish in 9 mins

guys,my heatsink arrived as cuz last time my griffin wont work in tc mode,but after use heatsink,still same problem,very weak power when fire,however the ohm reading is same with my obs crius,but it just fire so weak compare to my obs crius,like only fire at 10% compare to crius,well then switch to powermode then everything fine,power is almost as same as my crius...i check everything,no short error...
safety concern,should i stop using griffin even just for in powermode?

I see, interesting. Any brands in particular?

IINM, it's hard to bring liquids into China as they have extremely tight control over what goes into the country.
I'm sure there's a way around it. If you do find out let me know too, it would be interesting to know.

ada open house dekat umah sebelah .. sila join .. umah sini kolos

https://forum.lowyat.net/index.php?showtopic=4009513&hl=

This post has been edited by ekudz: Jul 21 2016, 04:28 PM

Folks.. bought this... Kepler 510 Finned Heat Sink for Atomizers via fasttech..

https://www.fasttech.com/p/4850401

however, it is not working at all.. Luckily fasttech refund me the money.. my question is: can anybody help out to point out which kepler working in fasttech.. really feel i need it... thanks in advance..

You need to tell.more about your setup and your.expectations frpm the heatsink. Nobody will reply your vague question.

sry,you're right,let me start from beginning...

I bought my Griffin 25 RTA last time,but it fire so weak so i suspect its shorting or bad 510 connection from my RX200,so then i order a heatsink cuz i saw someone said heatsink solve the 510 thread problem,but it dint solve mine. However,my previous tank OBS Crius v3 can fire no problem in both TC and VW mode,but my new Griffin only able to fire normally in VW mode,it fire so weak in TC mode,like only 10% of Crius when fire.
is it safe to keep using Griffin in VW mode?

My build
TC - SS316l,4 wraps,2.5mm,0.11ohm
VW - Kanthal A1,4 wraps,2.5mm,0.23ohm