but the quality......

PG already has amazing articulation, so panel lining + top coat usually good enough. However, it will looks even better if you paint it. (Although the process is PAIN)

See the below comparison and make decision :

welcome back
looking forward for more posts

got them too

too bad PG 00 raiser too expensive

better get MG 00 raiser...way better than PG

Planning to full set of the weapon customize too but where to get it?

thanks vorador

so perhaps i could only paint certain part for the PG, rather than every part? would it look weird after top coat?

This post has been edited by rx330: Mar 11 2014, 02:45 PM

lol sooper long no post in this thread liao.

any new sword-wielding gundams ah?

i finally done my PG ARF liao



is there RG ARF yet? i've seen the musha though. no likey

while mine is still in the box unassemble for 2 years hahahahhaha

mine also 2 years lololololol

got MG 00 QanT lor, unless u want the others

RM60 for all 6 at Fantasy Toyz LowYat

So sad.. Moving have to put all my MGs back to the box..



Quite a good scene stacking the boxes..

done
haish getting busy with commission works till neglected my WIP






This post has been edited by nazrul90: Mar 11 2014, 10:17 PM

around 380 plus shipping

finally finish my HG Double X, left topcoat...

my wallet damage today:

1. MG FAZZ : RM205
2. MG Full Armor ZZ Gundam : RM180
3. MG Hyaku Shiki (Ballute system) : RM120
4. MG G Armor : RM150

bye2 RM655...

help, my 3.0 have this problem, hand is loose already
any solution? or i have to accept this and move on

Blu tack.

3.0 hand the moment the joint pop off its forever loose, just reattaching it wont make any difference. Put a layer of super glue on the joint, let it harden first and then reattached it and see how. The extra layer of super glue could help in tightening the joint. If that fail then just accept it and move on.

last resort, or if your don't really use that wrist joint, just glue it permenantly