Yes, heard of this and tried too....what the hair dryer does is make the dented area more easy to push out but you still need to push from the back right? Also you will need a high powered hair dryer like those saloon one if only those house use small one you need 2 of them. It just makes it easier to push out. You can try, no harm.

Read ploperly, ayam seying if you take off the side bar, the bolt will fall INSIDE the chassis frame, it's a good chance Plotong give you anor excuse that your side bar installation causes the rattling sound ok Congratulations, you just stuck yourself into something really bad. Please go to the shop you installed the side bar, get them take the fuckin bars out together with the bolt WITHOUT cutting your chassis. Please record video also when they take it off, so I can learn a thing or 2 on HOW TO REMOVE AN OVERSIZE BOLT FROM A SMALL HOLE.

Why salty with rally short ratio geboks Jiu go ask FLXer with getrugged come autocross with us see who faster

yes, still need to push from back
hehehe, its good to have ur waifu / gf with long hairs. .
Y ? Damn sure u will have more than 1 hair dryers lying at home.
I got 1 normal dryer with a "turbo" function, higher output wind speed
and gf got saloon type dryer
good to go then

MCB, next time go NS have to go gunker house to greet him first for safe passage

Huai jiu insult our sifu 靓柴

+1 on this, yeah the screw once you jatuh inside....good luck on getting it back....I DIY install my side bar so yeah it's pretty difficult

It's the heat from the hair dryer important. More heat better can soften up the bumper more. My wife one can melt plastic if on full heat and full speed. I melted my wiper cover before with that....T_T

Hahahahaha....friends la..apa konco konco...

Scary shiet Nextaim u sit infront, I go to the back and close my eyes

just want to reassure, is it because of how the bolts are inserted into the chasis like the above video @ 8mins ?
I know not the same car and bar design but roughly its because of the way the bolt is inserted into the chasis and the hole stock diameter makes it not rekomended to remove after install ?

This post has been edited by ruby1288: Jan 23 2014, 06:27 PM

next tiem call sifu 1st b4 entering...damn hot, later kena MP5...


wa tak insult ler, u type wrg word le....

TitanRev dont mad ar, itu david type wrongly.... forgive me please....

I'll try and see.

Tomorrow got TT ah ?

Hai ya

I no mad la....mad what....

one way ticket once you decide to install side bars

Can take out, just need to be extra careful and patient. Also due to the nut is bolted in the bar screw hole which is deep once you loosen the nut the bolt will turn together making it hard to remove the bolt. The same with the UR "rear ARB" for gaga which I have previously and when I took it out the bolt and nut was very hard to take out end up I broke 1 of the screw off to take it out. With impact wrench and welding.

Dun dak jui gunker, else you can never set foot in NS again. If mau go Johor, kena masuk lalu Pahang. If mau go Melaka, kena lalu Pahang, masuk Johor, pastu u-turn ke Melaka

let me add this to my Android evernote

You can lalu pass Seremban.
Condition is u must go >240kph
If Gunker pakai R35 then different story la ok