My extractor cracked..and already weld it.but power kureng la..damn..

Guys.. i'm using 2.0" OD piping now.. Will ppl call me crazy if i change the mid section piping (from bullet to resonator) to 1.8" OD pipe? All i want is to get a lil bit more of backpressure..

current setup is 4-2-1 > 6" long of 2.0" OD piping > twist bullet > some 1 foot long of 2.0" OD piping > resonator > s-flow
Car is Gen2 1.6 AT non-cps

thinking of changing the 1 foot long of 2.0" OD pipe into 1.8" OD.. Any advice/recommendation?

beli je kt kaki exhaust for the time being..rm120 je. pastu kumpul duit beli powerzone 
u may get a lil backpressure for that. i've tried mine by enlarging the piping frm 1.8" to 2" between the nenas until resonator...and the length is lesser than 1 foot, yet i can feel the lose of the low end torque. depends on how much backpressure u want, u can try experimenting by resizing part by part into smaller piping. 

thanks for the useful advice bro

Guys, where to find FGK extractor? Thanks

Guys, where to find FGK extractor? Thanks

My extractor cracked..and already weld it.but power kureng la..damn..

i think there may be other cracks ur not aware of... have u gone through every single inch?

piping and muffler etc all got crack oso can affect u know...

when mine cracked i had it welded and the difference was significant..

EA Autoworks is selling it

Very hard to get stock now. The brand changed its name to FFK, apparently... LOL!!!

Same goes to my friend's Peugeot 206.

My friend did his first exhaust there. The shop recommended ridiculous setup with oversized pipes. Since my friend don't know much about exhaust so he just went with it. My friend's car FC dropped to almost 1/4, the car is vibrating unevenly and it's too loud even thought he specifically told him he wanted less noisy setup.

He went there twice to check what's the problem. He gave up and went to Sunway's SuperCircuit. They laughed the moment they saw a glimpse of the exhaust
I went to Everco yesterday to do my Viva. They quoted me RM1.9K for a full stainless steel setup 

looking for a stock rear muffler with 2.5" inlet...

the quieter the better... preferably a stock exhaust from some car... any idea wat car uses a muffler with that size inlet?

Extractor upgrade alone will of course make your exhaust sounds louder
So at the center, just install a big midbox or a bullet or two to lower the sound

I see I see. So bullet is not cat con?