I didn't fancy drilling a hole into the car. So I ordered mine through ebay. Any model also can. So long as it's large enough to cover the square hole which houses the license plate lamp. Preferable that it's using a Sony CCD chip.


See the pics which I posted. Last picture taken outside the car. Almost pitch black. Only one lamp pole about 35 feet away. The picture in the HU is what you get. It sees well enough under low lighting conditions.

i never install a VS bro...

nice camera....if buy le...can DIY?easy?
think wan to DIY to install it

Thanks. Does this mean the slight bulging in unavoidable? I guess I can live with that.

Hi,

From the ebay link you gave, the wiring... I doubt your installer can use them straight off the bat right? They have to make modifications to the wiring I guess... what about the connector to the back of the HU?

So far, the reverse camera you have got there seems to be the best looking i.e. not protruding too much and seems like a "natural" fit, among those which I have seen so far.

Thank you for sharing.

I only DIY pasang the camera at the rear only. Had accessory shop do the wiring. Less stressful for me. Scared to dismantle dashboard and run the wire under the carpet.

Go to preveclub forum. There's a thread with pictures detailing how to DIY reverse camera.

---

Added on August 8, 2012, 10:24 pmConnectors to the HU isn't that hard.

1) Take an old cd-rom audio connector cable & remove pins from there.
2) Sambung to your camera's RCA connector. Can potong and solder.
3) Stick pins into HU's connector. (which is removable)




This post has been edited by BartS: Aug 8 2012, 11:22 PM

Bro BartS, can you reply me pls ..many thanks...

Uhm .. I replied you in post #442

1) I didnt drill hole. I attached by using 3M double sided tape (same type as for visor). Even if tape falls out, it won't drop out because license plate located underneath it, wont allow it to fall.

2) Night vision is quite good. No need extra lighting sources even when it's dark.

This post has been edited by BartS: Aug 8 2012, 10:34 PM

Barts,

think you mentioned earlier that you did foaming too to your ride, did it improve on soundproofing?

can give the DIY link bro Barts?no able to find it ?

Guys, if the club is going to organize Futsal, would any of you join if the time is right after we did a poll?

---

Added on August 8, 2012, 10:52 pmThat's kinda relief Fulat bro! Thanks!

This post has been edited by Saya_Dhuang: Aug 8 2012, 10:52 PM

Many thanks bro , mind to tell how much dmg from KL auto? only buy Sony CCD enough rite and they will help to install wiring etc rite?? i plan to install reverse cam too but too sayang my prevay and try to not drill hole there...if got 'no drill hole' method, i will go n try it out.

Here's a better picture of my camera

hey preve cfe use timing chain or belt now? all new cars shld be chain right

There ya go .. http://www.preveclub.com/viewtopic.php?f=10&t=575

Now everyone talking about the reverse camera
Btw, how much the cost for wiring & the connector? Thanks a lot.

Yes it did. Hard to quantify with words; have to drive it to believe it.


Think they gave me a special price for the camera wiring. Only 1xx. Best if you call up the owner Desmond to inquire @017-2823073. I went to KL Auto because I wanted to do autofoam and I heard good things about them. Autofoam wasn't cheap but the CVT's whine was annoying me.

Note:
You don't need to go to KL Auto just for the camera's wiring. Any reliable accessory shop will do. Or even Drex's EA Autoworks@Bkt Jalil. Bring along wiring diagram to be on the safe side. I chose KL Auto because I know they are professional & NOT the type who only know how to buka and tak tahu pasang balik. In the course of doing autofoam today, many of my panels got dismantled. After refitting back, I'm glad to report there's no annoying 'krek krek' sound from improper assembly.

This post has been edited by BartS: Aug 8 2012, 11:39 PM

Any shop to recommend around subang jaya that can touch up a chipped paint/scratch?

very nice bro ...WWV!!! same here

Thanks, will contact the boss once i decide to do...but before that need order the SonyCCD first

After autofoam, no more whine noise?

Quoting Desmond the Poison King ..

I originally went to KL Auto to fix the whine but he showed me a bigger & more annoying issue with Preve. There's a boominess within our cabins. Have you ever had trouble hearing what the rear passenger is saying?

This post has been edited by BartS: Aug 8 2012, 11:44 PM

To Fulat bro,

Some of us including e is wishing tos e your latest car picture bro.. Hehehe

http://www.prevoc.org/forum/viewtopic.php?f=50&p=1264#p1264