i'm using dt-d43 and set 1/2 divider there to achieve 334 htt there...huhuhu...just wanna test how my opty can go there...

for 334x9 ldt i set to 3x if i'm not mistaken ...forgot oledi as now my mobo went to RMA...

currently using biostar tforce as a replacement...huhu

hai here's mine....... it's too hard to reach 3,0....how yah?? stepping is cab2e 0610 Gpaw

this one is already stable since I already primed it more than 8 hours..





This post has been edited by anggajaya: Jun 18 2006, 02:47 PM

any nforce3 user with opty going htt above 280 w/ 1:1 devider?

if w/ dfi for sure it max out around 280+ (2*512MB), not so sure w/ msi thou...

What vcore and LDT you set in bios?Did you try higher vcore for the opty to ran 3Ghz?

i ve tried so many things to achieve 3.0 but then It always failed...

first I tried to raise 1,5 vcore in bios and I set 133 as a divider...for htt I used 333 since there is no option for x2.5 at ldt....so I set 333 times 3... until I raised 1.5 to 1.52... it still failed....

btw king...Tommorow ok...please remind me In a message..so sorry for the long delay...

Glad to hear,you still remember havn't send the stuff.

Did you try x2 LDT?Which bios are you using?

This post has been edited by kingmaker_20: Jun 19 2006, 04:45 PM

Trying my luck for 3.0Ghz on stock vcore. CAB1E 0614 BPMW



Idle temp - 37-38C
Full load - 43C-46C
Bios set Vcore = 1.37V
Vdimm = 2.9V
LDT = 3X
HTT - 330x9
Mobo - DFI LP UT NF4 SLI-D Rev AA
HSF - metalzone's Budget WC kit

Sorry double post.

This post has been edited by kingmaker_20: Jun 19 2006, 05:05 PM

i tot wif this stepping u could do 3g at stock no prob...
but dun know la whether that 3g is stable or not...

urs is same as mine...
can hit 3g...prime no go...one time tried only, after that didnt try it again...that one wif 1.5x vcore...wif 0704bta bios...
flashed wif new 0406 bios but couldnt even load windows...
maybe i should flash back to 0704bta and give it another try for that 3g...

Super PI 32M passed on 3Ghz@stock but prime no go.Hope some burn-in will give me some luck to pass.

u all having a good luck, mine 146 max can do onli 2.95Ghz, even at 1.56V still kenot pass super pi 32mb. mebi bcoz of 2gb kit RAMs..
some times im thinkin' to remove the IHS of my opty

This post has been edited by gengstapo: Jun 19 2006, 09:27 PM

what's holding u back?

i notice u using oso using the same RAMs. can it do 300HTT?? wat the vdimm??

ps : still thinkin' bout warranty lorr

Maybe temperature because he said about removing the IHS.

Maybe you should pass your rams to me for a week.

2gb kit uccc doing 300fsb
damn lucky if i can get it stable at 265...300 is like

Even if can stable 270-280 considered very lucky.

try one stick RAM and see how .