So you confirm won't explode eh ... so tempted to try mine 
ya , I found that your speed is Top 1 among maxis users thus far ,    for you

that means tp-link TD-W8968 can plug in 3g modem? mayb consider buy 1 unit..

Bro Chuah. I have reflash back to stock firmware and flash it back to openwrt and good news is i success in putting in 2 DNS now    but........... Now I have 4 DNS   

[attachmentid=3147756]

oh i see.. where can get version 2.0?

You pawned SiFu Chua kawkaw,



trust me go for this, 2 versions, rm240 and rm350 ( hav doubled RAM, new CPU and all five gigabit ports )

http://routerboard.com/RB751G-2HnD

Best value for a Commercial Router and is DDWRT supported too.

jealous....

whats ur signal str without the antenna?

you have both MF680 n E372 is it ?

O-LEDI order, waiting for mr poslaju man......

yours before = 55%, after = 87% (with Panel antenna and TX33), increase of ~30%

mine now without antenna and TX26 = 74%, so if add-on Panel antenna and TX33 will be >100% assuming same increase of ~30%??

handy guide? what handy guide?

u mean the review previously ? i cant find that thread anymore.....

bro,ask you, stock firmware more stable or ddwrt? stock can see signal strength but ddwrt cant see in percent

Darn, another poison frm sifu

Any effect on speed & stabilty by using maxis default DNS ? i saw you key-in manually 8.8.8.8 / 8.8.4.4

... and able to access to certain sites too

Just finished test new mr3420v2+my old modem.

max reception i can get is 22%
download is around 1~1.2Mbps
the speedtest location default is Johor
(hotlink prepaid broadband)

my place is quite rural, apartment building ground floor facing the hill, my unit was like near the top of the hill, and the only tower visible is at the bottom of the hill. good thing my modem still can get green light.

Dear all, may i know is TL-MR3420 V1 support ZTE MF680 or Huawei E372 ? any one tried it before...? was thinking to get 1 from blacktubi... thanks

Thanks for you guys    bcos i don't see them in the support list
Btw, which one are recommended ? thanks again

wanna to ask ~
could we can open port for port forwarding if using this router ?

speed today with E367 (TX27) +MR3420(OpenWRT) + patch panel antenna. Cannot get the same speed what ever i do if direct connect to laptop....

ah....like that ka? my laptop is Dell XPS M1530 (yes, i know it ancient artifact already, but at the time that i bought this laptop, its the best of best  ) dont have the kind of usb port that you mentioned...any workaround? because sometimes i need to take the modem on the road and direct plug in to the laptop....  

Wat ever Y cable or Lightning port also come to "no use" , because if you use the PC/Laptop for some time, the whole damn mobo gets heated up and when there is too much heat on the mobo, the whole circuit will slow slow dei , meaning your system and USB connection/data transmission also slow slow dei...........

to over come this , dun use WiFi as WiFi also consume power, dun use USB plug-in as this also gets jammed up with less power as its  being "eaten" by the mobo........connect via LAN cable from the Router , as LAN routes dun utilise power (CAT6e LAN Cable ~ faster transmission, proven with low ping ) ~ btw, also disable WiFi from the router as that the router dun have to power up the WiFi Chips and fully utilise the 1A of electricity to suck in the signal into the modem.

ah....like that ka? my laptop is Dell XPS M1530 (yes, i know it ancient artifact already, but at the time that i bought this laptop, its the best of best  ) dont have the kind of usb port that you mentioned...any workaround? because sometimes i need to take the modem on the road and direct plug in to the laptop....  

@Chuah

Have you used a CAT6e cable to benchmark before?

If not you should try, after that you would "hard sell" this cable like you have been doing to OpenWRT these past week again

 

---

Added on November 11, 2012, 4:24 pm@Chuah

Have you used a CAT6e cable to benchmark before?

If not you should try, after that you would "hard sell" this cable like you have been doing to OpenWRT these past week again

 

That cable have could have some broken bits inside.

I tried a Cat5 ( supplied with the V2 and the ping averages at 100~120ms, whereas my Cat6e cable, longer at 2meters ping at abt 27~100ms, averages 45ms ~ current LIVE result , via Router only........
[attachmentid=3150375]

That cable have could have some broken bits inside.

I tried a Cat5 ( supplied with the V2 and the ping averages at 100~120ms, whereas my Cat6e cable, longer at 2meters ping at abt 27~100ms, averages 45ms ~ current LIVE result , via Router only........
[attachmentid=3150375]