Welcome Guest ( Log In | Register )

Bump Topic Topic Closed RSS Feed
116 Pages « < 62 63 64 65 66 > » Bottom

Outline · [ Standard ] · Linear+

 ★★★ LYN PROTON WAJA Club - V12 ★★★

views
     
armadasaxon
post Nov 11 2011, 02:47 PM

Casual
***
Junior Member
488 posts

Joined: May 2009
From: damansara


hello sifus,
can waja 03 smelly aircon be due to dirty aircon filter?
dinwaja
post Nov 11 2011, 03:16 PM

Casual
***
Junior Member
421 posts

Joined: May 2010
From: Seri Gombak


QUOTE(Nightstalker1993 @ Nov 11 2011, 02:05 AM)
Hey guys, wanna ask if you can just cut the rubber seal of the headlamps if you wanna open it? Wanna do this DIY mod but i read other place say best use heatgun or hairdryer to melt the seal instead of cutting it sweat.gif

http://wajaclub.forumotion.com/t33-diy-smoke-headlamp
*
last time when i DIY my headlamp, i don't used any heater...i just let the sun heat it (haha)...but not too long....then i slowly and carefully 'kopek' like 'kopek durian'...
Nightstalker1993
post Nov 11 2011, 03:59 PM

M� �R�|�
*******
Senior Member
8,930 posts

Joined: Nov 2005
From: Subang Jaya


Dares: well, it works? laugh.gif and if that's the purpose, i doubt those small tiny pads can do the job lol. Rather get something from Dynamat or STP.

Dinwaja: leave it out how long bro? 30mins enough? So after that you clean off the old sealant and seal it with silicone, correct? laugh.gif
LazyKurosaki
post Nov 11 2011, 04:07 PM

Master of Donut
******
Senior Member
1,139 posts

Joined: May 2010
From: Petaling Jaya



imma imma be be......... im sexy n i know it
dinwaja
post Nov 11 2011, 05:08 PM

Casual
***
Junior Member
421 posts

Joined: May 2010
From: Seri Gombak


QUOTE(Nightstalker1993 @ Nov 11 2011, 03:59 PM)
Dares: well, it works? laugh.gif and if that's the purpose, i doubt those small tiny pads can do the job lol. Rather get something from Dynamat or STP.

Dinwaja: leave it out how long bro? 30mins enough? So after that you clean off the old sealant and seal it with silicone, correct? laugh.gif
*
hm..dun quite remember edy but around 30min-1hr is enough...just put it under direct sun....but remember to peel it off very careful. yeah, clean as much as u can then seal it with new silicone...use the gun...buy it from shop la...without the gun,it is a total mess....and tiring...1st seal it inside...then seal it again around the headlamp (outside the cover)...double protection...
reef_d
post Nov 11 2011, 05:42 PM

Getting Started
**
Junior Member
264 posts

Joined: Jan 2003
From: Putrajaya



i think i will give the cheapo pads a try.. just wanna make my engine bay looks nicer actually.. the old oem layer looks saggy and could come off anytime.. price wise is rm50 only so not much too complaint.. dynamat the hood how much? last time i asked its almost 400bucks woh.. sweat.gif
armadasaxon
post Nov 11 2011, 06:04 PM

Casual
***
Junior Member
488 posts

Joined: May 2009
From: damansara


Anyone can recomend ppl that can do good PU front lip bodykit + spray?TQ
movies2u
post Nov 11 2011, 08:41 PM

New Member
*
Junior Member
15 posts

Joined: Nov 2009
need some help.. my car is proton waja mmc 1.6 tahun 2005..
aku nak tuka spark plug.. ada masalah skit la..
nak cabut cable die tu kena pulas/screw/pusing2 or tarik?? takot ada yg rosak pulan nnti.. gamba yg aku attach ni la cable spark plug yg kena bukak tu kn?

macam ada 2 cable aje.. yg lagi 2 tu mcm kena bukak skru atas tu dulu baru boleh bukak cable dia?

http://postimage.org/image/3thqj64mz/



Attached thumbnail(s)
Attached Image
eriyque
post Nov 11 2011, 09:02 PM

New Member
*
Newbie
0 posts

Joined: Apr 2009
Just remove cat con and change new muffler today ^^


Attached thumbnail(s)
Attached Image
dinwaja
post Nov 11 2011, 09:08 PM

Casual
***
Junior Member
421 posts

Joined: May 2010
From: Seri Gombak


QUOTE(movies2u @ Nov 11 2011, 08:41 PM)
need some help.. my car is proton waja mmc 1.6 tahun 2005..
aku nak tuka spark plug.. ada masalah skit la..
nak cabut cable die tu kena pulas/screw/pusing2 or tarik?? takot ada yg rosak pulan nnti.. gamba yg aku attach ni la cable spark plug yg kena bukak tu kn?

macam ada 2 cable aje.. yg lagi 2 tu mcm kena bukak skru atas tu dulu baru boleh bukak cable dia?

http://postimage.org/image/3thqj64mz/
*
nk bukak empat2 kn? kat coil tu jgn la x tanggalkn skru tu dl...yg lg 2 tu blh cabut jer...tp jgn terlalu kuat sgt...yg penting ko kena ada yg bentuk "T" remover tu...
movies2u
post Nov 11 2011, 10:05 PM

New Member
*
Junior Member
15 posts

Joined: Nov 2009
QUOTE(dinwaja @ Nov 11 2011, 09:08 PM)
nk bukak empat2 kn? kat coil tu jgn la x tanggalkn skru tu dl...yg lg 2 tu blh cabut jer...tp jgn terlalu kuat sgt...yg penting ko kena ada yg bentuk "T" remover tu...
*
so bole cabut/ tarik perlahan2 la?
ThunderGod_Cid
post Nov 11 2011, 10:16 PM

Getting Started
**
Junior Member
158 posts

Joined: Jun 2009


someone downgrading waja : parts for sale

http://forum.lowyat.net/topic/2104062
dinwaja
post Nov 11 2011, 10:16 PM

Casual
***
Junior Member
421 posts

Joined: May 2010
From: Seri Gombak


QUOTE(movies2u @ Nov 11 2011, 10:05 PM)
so bole cabut/ tarik perlahan2 la?
*
blh..tp nk keluarkan spark plug tu kena la pakai pemutar 'T' tu...
movies2u
post Nov 11 2011, 10:33 PM

New Member
*
Junior Member
15 posts

Joined: Nov 2009
QUOTE(dinwaja @ Nov 11 2011, 10:16 PM)
blh..tp nk keluarkan spark plug tu kena la pakai pemutar 'T' tu...
*
ok bro.. dah try tadi.. memang kena tarik kuat skit baru boleh kuar...
TQ!!!
dinwaja
post Nov 11 2011, 10:42 PM

Casual
***
Junior Member
421 posts

Joined: May 2010
From: Seri Gombak


QUOTE(movies2u @ Nov 11 2011, 10:33 PM)
ok bro.. dah try tadi.. memang kena tarik kuat skit baru boleh kuar...
TQ!!!
*
sama2...engine kita sama...
brewoe_1988
post Nov 11 2011, 11:01 PM

Getting Started
**
Junior Member
175 posts

Joined: Mar 2006



QUOTE(eriyque @ Nov 11 2011, 09:02 PM)
Just remove cat con and change new muffler today ^^
*
whats the effect??more pickup...
ThunderGod_Cid
post Nov 11 2011, 11:31 PM

Getting Started
**
Junior Member
158 posts

Joined: Jun 2009


I hav a set of TOPCAT centre box, and rear muffler(semi s-flow) for sale, both to fit waja. RM300.00 negotiable, suits both auto and manual, 2inch inlet. Bought for close to 600.00, age of items less than two years old

Get my number from my signature if anyone is interested. do not PM


cheers
eriyque
post Nov 11 2011, 11:35 PM

New Member
*
Newbie
0 posts

Joined: Apr 2009
QUOTE(brewoe_1988 @ Nov 11 2011, 11:01 PM)
whats the effect??more pickup...
*
for me same... hahhaha.. diffrent is ekzoz sound more louder... effect will be more better after i bot on end of month ^^
now still cant see the diffrent
dares
post Nov 12 2011, 11:13 AM

Enthusiast
*****
Junior Member
834 posts

Joined: Jul 2011
QUOTE(eriyque @ Nov 11 2011, 11:35 PM)
for me same... hahhaha.. diffrent is ekzoz sound more louder... effect will be more better after i bot on end of month ^^
now still cant see the diffrent
*
drool.gif

On an unrelated note. A couple of days ago I went to workshop to service my car. The workers were working on a Kembara that looked quite beat-up, all scratching their heads. I ask the head foreman what's wrong, he told me the car airon pulley and belt gone missing, therefore no aircon and power-steering.

How can the whole thing just go missing!!?? shocking.gif rclxub.gif


Added on November 12, 2011, 11:17 am
QUOTE(ThunderGod_Cid @ Nov 10 2011, 02:45 PM)
Badges are available RM40/pair, black and silver
*
Like this one?

user posted image

I'm interested but dunno how to install...especially the back. rclxub.gif

This post has been edited by dares: Nov 12 2011, 11:17 AM
ThunderGod_Cid
post Nov 12 2011, 12:00 PM

Getting Started
**
Junior Member
158 posts

Joined: Jun 2009


yep. buy me dinner i install for you tongue.gif

116 Pages « < 62 63 64 65 66 > » Top
Topic ClosedOptions
 

Change to:
| Lo-Fi Version
0.0309sec    0.34    6 queries    GZIP Disabled
Time is now: 15th December 2025 - 03:22 AM