lol owikh84 show a good pic!!!
sleep mode...

If i add 1 more gpu block?

dont really matter if u r picky the radiator after pump cause pump produce heat as well so that way it gets the lower temp coolant as possible but yea thats if u r really anal ; ;

let it run for a while to properly blled the system my old system with a swiftech 320 + 240 after bleed will only drop about 1-2 cm of the res lvl but looking at ur pic u nearly fill ur res to the top ; ; half way is a good starting point

Yaya..quite slipy..haha

hahahaha... dont play play bro....

ok will try it... yes as i mentioned there dy... performance not 100% yet... cos got a lot bubbles inside... somemore now just realize my radiator not even full fill coolant.. really

your procedure is

lay down casing
fill water (vertically)
jump psu start
let it running

am i rite?

you can also have it running and tilt it. shake it. turn it upside down (please do this while the pump us turned off).

as for starting, i filled coolant then jump start then off then filled again... repeat & repeat

but until the res getting full.. i cant fill liao.. so i start... wat i saw is massive pull out by pump then coolant from radiator just baru filling back to reservoir... yes, i also feeling that radiator still got air inside....

Bt between tis 2 method,got different performance?

nope in theory yes but in the real world it dont always work out

Yaya..quite slipy..haha

---

Added on August 22, 2010, 4:54 pmBt between tis 2 method,got different performance?

---

Added on August 22, 2010, 5:07 pmOh..ok..thks bro,haha.wat cpu block is d best?

This post has been edited by alan kc: Aug 22 2010, 05:07 PM

yes, that's the way. not necessary to fill coolant fully in ur res
just make sure coolant surface exceeds the top tube is enuf.

give u an idea on how the radiator works

How Radiators are made

btw, what u mean top tube?

as my inlet tube is at the top cap but at the side... meaning terbalik reservoir and inlet at side cap... i know u get what i mean..

is it your meaning is like my drawing??

i kinda stupid..

---

Added on August 22, 2010, 5:43 pmas my reservoir inside dont have tube like what advance x2 have

This post has been edited by subrok007: Aug 22 2010, 05:43 PM

U jus terbalik d rev then place d inlet and outlet at bottom,all problem wil b settle.

just realized that ur res is V2 haha
do like wat this fella said

This post has been edited by owikh84: Aug 22 2010, 06:01 PM

yes mine is v2 only....

ok ok.... will try terbalik back in normal position....

thanks bro for help out

Normaly d rev design is for u to place d inlet and outlet 2 gether in bottom,d upper hole is for u to fill up d coolant.

then i geh kiang lo.... terbalik it....

but if i put a tube inside reservoir, will it solve my problem?

Er..i dun thk so..coz d coolant inside d radiator and wb need d pressure to make d cooland stay inside d rad and wb..so ur inlet need to place at bottom,so d rev coolant wil force d coolant flow out frm d rad and wb when u off d pc.

u can do vertical flow with X2 basic and adv only. link
don't think V2 has this kind of bottom accessories.
actually u can route the tubing thru PCI slot opening there but it's going to touch that slot. ur tube is too fat