tis was my 2nd time using barb n everything was ok up until i decided to reroute the tubing. A bit of crazy setup,1st n 2nd one, y-blocks for the 1st setup n much more tubing for the 2nd. May be i overheated this one end of the tubing,expanding it too much,using a heat gun,mind u,he2.

looking for a bench tat can mount tri radiator. Any intro. lolx

Technofront Raven is the only test bench available locally.
i wouldn't comment on the price as it is "made in Italy" (for Italian)

This post has been edited by owikh84: Sep 14 2011, 06:34 AM

any other test bench available? kinda interesting

Dismatech Easy/Hard etc and Microcool Benchetto can be imported from overseas.

But expect shipping fee to cost a bomb. I told myself not to think too much about shipping cost but take it as the total price of a case. And there comes my LD.

This post has been edited by owikh84: Sep 14 2011, 08:43 AM

the one used by "coolice" or in OCDRIFT is which brand?

---

Added on September 14, 2011, 10:29 amthis one

http://forum.lowyat.net/topic/1826879

This post has been edited by Dennos: Sep 14 2011, 10:29 AM

lubic kit. last time got seller in lyn

600 for a test bench is quite ok already .
considering u cant get them in malaysia, and to bring in on ur own, shipping cost would be bombastic .
not to mention the risk of damaging the item during shipment .

A, B and C

which one is the best?

---

Added on September 14, 2011, 5:56 pmi saw all these 3 setting from google.

C is horizontal setting.

This post has been edited by Dennos: Sep 14 2011, 05:56 PM

C is the default setting for EK res with anticyclone. You need the tube on the ceiling to trap the air

vertical mount similar to C with tube as inlet, and no anti cyclone, but outlet at bottom, is it ok?
from above setup, will i see cyclone inside?

anything wrong on this setup? will start operation my wife soon.

what the purpose of T-block?

this is a good question, i think t block wit one of the outlet can be used for filling and draining. lolx
any comment?

Your T block will be absolutely useless there. For draining the T block must be all the way at the bottom. If you put a T block there, the water will flow out from the rad once you open the fittign

too high for draining

what kind of res is that?multioption or microres? if its a bay res,surely can put at 5.25" bay,easier for filling...

can put the drain port at the lowest part of the loop,easier draining process

tat is bitspower z multi, i still don really understand the purpose of tube inside, should i seal all the extra outlet/holes with stopper?.

bitspower got 4 lubang. one on the right and 3 on the left.

Just finish my wc setup, took me a whole day, first time doing this with help of my friends also wc noobs hahahha...


Attached thumbnail(s)

nice wc setup